Dodge Cummins Diesel Forum banner
1 - 1 of 9 Posts

· Registered
149 Posts
I need to drill a small hole in the back or side of the storage slot directly below the radio in my 2009 2500 to run wires for a trailer brake controller.
Does anyone know the easiest way to remove the dash cover around the radio so I can check out what is directly behind or beside this area?
Don't want to drill without knowing what's what.
Any help would be appreciated. :confused013:

on my 03 it just unclips with one the middle. the 09 should be close to the same. pull any screws you see on the front and bottom of the dash. then start on the driver side by the door and pull on the panels. be careful pull slow they should come out pretty easy.
  • Like
Reactions: WDE
1 - 1 of 9 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.