[metalli445]

I just purchased a 6.7 based CP3 for my truck to replace my 5.9 CP3 and the feed line has been relocated. Many years ago I purchased a big line kit which runs from my fuel filter housing to the CP3 (#1 in picture) and the fitting is tapped for a line that goes back to my fuel regulator and then to my fuel pressure gauge(#2 in the picture). I'm having trouble finding a fitting that is will replicate my current setup. I've attached a picture of my current setup. Does anyone know where I can purchase a fitting to work with the new CP3? I'm thinking I need a straight fitting that is tapped to accept the fuel gauge line. How do other people have their mechanical gauge hooked up? Any help is appreciated.

 

[metalli445]

@metalli445 sorry for the slow response on here and email. Why not run a new big line and a sender t in the middle of that line so that you have a single fitting going into the cp3? What year is your truck?

No problem. I know I reached out to you late night and I think it was on the weekend but I did end up going the same route you mentioned. I'm just seeing this post but I'll reach out again for other parts.