Dodge Cummins Diesel Forum banner

CP3 Fitting

491 Views 3 Replies 3 Participants Last post by  metalli445
I just purchased a 6.7 based CP3 for my truck to replace my 5.9 CP3 and the feed line has been relocated. Many years ago I purchased a big line kit which runs from my fuel filter housing to the CP3 (#1 in picture) and the fitting is tapped for a line that goes back to my fuel regulator and then to my fuel pressure gauge(#2 in the picture). I'm having trouble finding a fitting that is will replicate my current setup. I've attached a picture of my current setup. Does anyone know where I can purchase a fitting to work with the new CP3? I'm thinking I need a straight fitting that is tapped to accept the fuel gauge line. How do other people have their mechanical gauge hooked up? Any help is appreciated.

Motor vehicle Automotive exterior Gas Auto part Bumper
See less
I just purchased a 6.7 based CP3 for my truck to replace my 5.9 CP3 and the feed line has been relocated. Many years ago I purchased a big line kit which runs from my fuel filter housing to the CP3 (#1 in picture) and the fitting is tapped for a line that goes back to my fuel regulator and then to my fuel pressure gauge(#2 in the picture). I'm having trouble finding a fitting that is will replicate my current setup. I've attached a picture of my current setup. Does anyone know where I can...
See more
1 - 4 of 4 Posts

· Registered
Joined
·
1,428 Posts
Discussion Starter · #4 ·
@metalli445 sorry for the slow response on here and email. Why not run a new big line and a sender t in the middle of that line so that you have a single fitting going into the cp3? What year is your truck?
No problem. I know I reached out to you late night and I think it was on the weekend but I did end up going the same route you mentioned. I'm just seeing this post but I'll reach out again for other parts.
 
1 - 4 of 4 Posts
Top