Dodge Cummins Diesel Forum banner
1 - 5 of 5 Posts

· Registered
Joined
·
17 Posts
Discussion Starter · #1 ·
hey whats going on. ight i have 2005 dodge cummins 2500 with a straight pipe exhaust and intake. i have a smarty s06 chip but i wanted a monitor on the dash board too read my egts and ect. i dont wanna get rid of the smarty but i was wondering what goes with the smarty that i can just plug in and not mess up my smarty tunes. im looking for a monitor pretty much only.
 

· Registered
Joined
·
327 Posts
Not juiced with attitude, just the monitor itself is what Norris is saying. You can also change your power on demand through the edge cts running from your smarty. Can't change the SW level on smarty through edge but say you're on 5, you want to tone your truck down a little, on your edge you can turn it down to 75 or so and it'll cut some power/pedal position for fuel and changes shifts because of throttle usage depending on how far you turn it down. Most everyone runs that setup with a smarty if you want monitor not analog.
 

· Registered
Joined
·
132 Posts
Yeah Edge CTS monitor. unfortunately I bought an edge programmer before I read a lot on the s06 :( . Some day I'll get a smarty and run my edge on stock just for a monitor until I can afford a CTS

I got an idea. You can buy my edge and just run it on stock for a monitor?! :)
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top