Dodge Cummins Diesel Forum banner
  • Hey everyone! Enter your ride HERE to be a part of September's Cummins of the Month Challenge!
1 - 13 of 13 Posts

·
Registered
Joined
·
701 Posts
Discussion Starter · #1 ·
Just Installed a CFM+ (who says you cant install one on a truck with a brake booster??) and i am pretty damn impressed, better throttle response, faster spool, worth the investment.:woot:
 

·
Registered
Joined
·
661 Posts
hey how well does that hx40 burn the fuel on your rig...does it clean it up at all???
 

·
Premium Member
Joined
·
5,204 Posts
I have never heard of one exploding because of too much boost
There is one thread out there about one that blew up. But I think he drilled it...a big no no. They are a very good intake.
 

·
Registered
Joined
·
861 Posts
i have never heard of them blowing up ever. but i have seen dyno sheets of others compared to CFM+ and the CFM was th best by a good amount
 

·
Tech Specialist
Joined
·
2,458 Posts
I have heard of people drilling them and having bad luck (I ordered mine with the 3-ports) ... and I have also heard of people over-torqueing them, and causeing damage that way.

But I NEVER heard of one exploding due to boost pressure ...
 

·
Registered
Joined
·
701 Posts
Discussion Starter · #9 ·
I have never heard of one exploding because of too much boost
a buddy of mine running in the 10's uses one. told me to take a look at one. im sure there will be some failures here and there on ANY product but i doubt 35lbs boost will even make it yawn
 

·
Registered
Joined
·
685 Posts
never said i didnt believe you..im sure it could happen...just unlikely.
It wasnt meant for you.

It was for the other two who said it couldnt happen.

Just be careful with that thing.

I personally am building one out of 304 polished 3" Stainless, with a few ports on it.
 

·
Registered
Joined
·
701 Posts
Discussion Starter · #13 ·
It wasnt meant for you.

It was for the other two who said it couldnt happen.

Just be careful with that thing.

I personally am building one out of 304 polished 3" Stainless, with a few ports on it.
Mine is the plus so it has the 3 ports. water/meth is next on the agenda.
 
1 - 13 of 13 Posts
Top