Dodge Cummins Diesel Forum banner

Can you drill and tap a banjo bolt to work for a fuel pressure gauge

2342 Views 4 Replies 4 Participants Last post by  No_Cash
I bought a bango bolt for a diesel shop and was going to drill and tap it to 1/8 to fit the sender on the fuel press gauge will it work ?
:confused013:
1 - 5 of 5 Posts

· Registered
Joined
·
9,910 Posts
yes, alot of people go with that method for a fuel pressure tap.
 

· Registered
Joined
·
175 Posts
Discussion Starter · #4 ·
Do you have to put the spring and ball back in it
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top