Dodge Cummins Diesel Forum banner
1 - 1 of 3 Posts

· Registered
54 Posts
Discussion Starter · #1 ·
I posted this in the towing section, but I dont think it gets much exposure over there...

Okay here is the Problem: I have a new (and tested on another vehicle) brake controller (Prodigy) and brand new wiring pigtail for the prodigy. I get brakes to the trailer when I use the manual lever, but not through the pedal. I put a meter on the red wire(at the factory socket for the brake controller) to the prodigy today, and got no output from the brake pedal switch when I engaged the brake pedal.

I am going to start digging deeper in to the wiring but wanted to make sure there wasn’t some known “gremlin” in the system before I embark on this.

Any experience or help with this is appreciated.
1 - 1 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.