Dodge Cummins Diesel Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
49 Posts
did you check for leaks everywhere. seen a few steel lines rust out up here. If you don't see any leaks make sure you check the rear wheel cylinders. If it is the booster/master cylinder make sure you bench bleed the master cylinder. just put it in a bench vise fill it up w/ fluid and pump it to get it bled well, then put it on. then you'll have to bleed each wheel.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top