[bulldog77]

Planning on a big set of twins. Going to start accumulating parts over the summer time summer i run the s466. The s466 is a 66/83 or 85( can't remember).91ar. Bottom turbo will be no smaller than a 90mm, hx 80 series or garrett. Steed speed comp t4 straight flange will be the exhaust manifold. Fueling I'd still being thought of. This will all be in a 2wd for drag racing. Any thoughts or concerns?

Sent from the recliner butt naked

 

[TurboDonVP44]

should be enough air for a 1000hp.
your concern should be having a LOT of money to fix broken parts.
is your truck full caged? i hope so

 

[bulldog77]

It will be caged. I might even start next month tearing it down and slowly start building.

Sent from the recliner butt naked

 

[TaterSalad]

hold onto your a$$...

 

[renopker]

It will be caged. I might even start next month tearing it down and slowly start building.

Sent from the recliner butt naked

Why tear it apart, start with nothing and build a truck

 

[bulldog77]

Its still kinda in the planning stage.

Sent from the recliner butt naked

 

[zfaylor]

Oh my....

I assume your doing a cam and some other goodies to help spool??

 

[bulldog77]

Yes. Actually been on the phone with a couple cam places this week talking about it.

Sent from the recliner butt naked

 

[bulldog77]

My so so list

Ported head fire ringed, shelf machined off but still undecided on intake.
14mm studs
Balanced bottom end
Stud girdle
Fuel system still being talked about.

Just some stuff so far, other nic nacks being discussed.

Sent from the recliner butt naked

 

[PowerStrokin]

Just a FYI a certain sponsor on here has a new head and intake runner combo for $2500 and it flows about 250cfm