Dodge Cummins Diesel Forum banner
  • Hey everyone! Enter your ride HERE to be a part of September's Cummins of the Month Challenge!
1 - 5 of 5 Posts

·
Registered
Joined
·
56 Posts
Discussion Starter · #1 ·
Any ideas on the best place/ or method to install mini switches on an '08 without drilling holes all in the dash?

Pictures?
 

·
Registered
Joined
·
756 Posts
im gonna put mine on either side of the exhaust brake control .. i kno u sayd not drillin into the dash but i think they would look good there im puting 3 on each side
 

·
Registered
Joined
·
674 Posts
get an a pillar gauge pod and put them on the side of that. you can always take it out and its easy to change
 

·
Premium Member
Joined
·
917 Posts
I have an '07 and what I have done is just remove some of the pockets in the dash and make a filler plate to mount the switches in. I installed a CB radio in my truck where the pocket used to be in under the radio and it worked out perfect. Most of the pockets in the dash come out with a couple of screws. However, it all depends on how your truck is equipped.
 

·
Registered
Joined
·
56 Posts
Discussion Starter · #5 ·
I was thinkin the pocket under the radio and just making a filler plate.
How the hell do you get this dash apart though!!!

I've never had one this hard, they use to just pop off with a little tug.


Anybody out there with pictures??
 
1 - 5 of 5 Posts
Top