Dodge Cummins Diesel Forum banner

Banks Twin Ram Air

1093 Views 7 Replies 3 Participants Last post by  pos dodge
Does anyone know if these are worth the money. I dont know of anyone running one. Any input would be appreciated. Im either going to get an arcflow or the twin ram.
1 - 8 of 8 Posts

· Registered
Joined
·
693 Posts
I have one and think its worth it. Made it run much smoother when working it.
 

· Registered
Joined
·
163 Posts
Discussion Starter · #3 ·
Thanks

Thanks for the reply. Does it replace the original heater grid with a blank or just empty hole in the back?
 

· Registered
Joined
·
3,126 Posts
im not a big believer in intakes for mild trucks. I think you can spend 700 else were and get better power gains especially on a 12v.... but that just me
 

· Registered
Joined
·
163 Posts
Discussion Starter · #5 ·
Thanks

im not a big believer in intakes for mild trucks. I think you can spend 700 else were and get better power gains especially on a 12v.... but that just me
I know that the arcflow made a modest improvement on my commonrail with just a programmer and exhaust. And i can get a new arcflow for 260 or a new twin ram for 500, i was just trying to compare the two and get the best one. Have you ever tried one?
 

· Registered
Joined
·
693 Posts
your original grids go in the housing that come with it. one in the front one it the back.
 

· Registered
Joined
·
3,126 Posts
never tried one... plus i know alot of guys making big numbers on a stock intake... but if you can get a deal go for it.
 

· Registered
Joined
·
163 Posts
Discussion Starter · #8 ·
Thanks

Thank you guys for your help. I think if you tried one you would like it. When i first put the one on my 06 i noticed an immediate difference in spoolup and i lost 4 pounds of boost. At first i thought that was bad, then i learned that boost was actually a restriction. Im sure that some people would disagree but i was pleased with the results, plus the pre-drilled ports make it user friendly for nitrous and a boost gauge or water. Thats kinda like the guys honing out the fuel rails on the common rails and claiming big numbers and then you have people saying that they were making big numbers without the rail being honed. And then asking well what kinda numbers could he have made if he had the rail honed. To each his own. Thanks
 
1 - 8 of 8 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top