Dodge Cummins Diesel Forum banner
1 - 4 of 4 Posts

· Here to learn
Joined
·
1,884 Posts
Discussion Starter · #1 · (Edited)
About a month or so ago, I changed out my wheel hub assembly. After I got the hub on, I went to plug in the ABS wire and the connectors are different. I don't know why. I ordered a Timken wheel hub for a 4WD 03-06 Ram 2500 (mine is an 07, would they change connectors on 07's???). Obviously it was too late to take off and send back to the company. The original ABS sensor was shot as my wheel bearing was gone and was unable to be transfered to the new hub. So I cut off both connectors and just wired them together. ABS is still on. I switched the wires around. ABS light is still on. Any ideas of how I can get my ABS light off? I went to the dealer to get a new sensor, but they wanted like $190 for it. :hehe: So I walked out. Help me please.
 

· Here to learn
Joined
·
1,884 Posts
Discussion Starter · #2 ·
Anyone help me out?
 

· Here to learn
Joined
·
1,884 Posts
Discussion Starter · #3 ·
Nobody?????
 

· Here to learn
Joined
·
1,884 Posts
Discussion Starter · #4 ·
Bump.......
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top