Cummins Diesel Forum banner

6.7 with smarty?

2K views 15 replies 10 participants last post by  nathan s 
the flo pro is just pipe,right? the edge is still allowing regens. set to stock, and remove the injector harnesss, leave the obdII plugged in, install smarty with ME software and enjoy. there is a couple issues to address when you install the smarty , so just read the directions carefully. you can run the mp8 but it isnt recommended, just make sure the rail pressure setting on the smarty is on1, and you can still adjust the mp8
Or take the MP8 off .. save your headgasket and use the Smarty as it was designed to be..LOL

:hehe:
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top