Dodge Cummins Diesel Forum banner
1 - 1 of 5 Posts

· Registered
265 Posts
I had the same problem and I just put the down pipe on and the rear section and made sure they fit right where I wanted them. Then I measured the muffler and mesured from the rear section to the long section and made a mark and cut at the mark and it fit pretty good after that. Just make sure the rear section is together right and the hump is over the axle where it should be before you cut.
1 - 1 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.