Cummins Diesel Forum banner

5" exhaust install

899 Views 4 Replies 3 Participants Last post by  RaMatt
Ok so im installing my rollin smoke diesel 5" kit with muffler and I had a couple of ?s does anyone have pics of it installed. I have a quadcab short bed and I have the downpipe and the long straight piece installed but I was wondering how much to cut off the straight pipe so that the muffler fits Im also curious how the hangers go on tailpipe section. I think some pics of underneath someones truck would help tons. Thanks
1 - 5 of 5 Posts
if I remember right somewhere in the instructions its tells you the point to measure and cut on the downpipe but not quite sure though mines a mega so I used all the pieces
yea the instructions dont say anything where it does talk about cutting downpipe thats for the cat.
yea the instructions dont say anything where it does talk about cutting downpipe thats for the cat.
ok then well whats the exact difference in length from a short bed to long bed cut off that much and you should be set. Not sure off the top of my head exactly what it is so wont even guess
I had the same problem and I just put the down pipe on and the rear section and made sure they fit right where I wanted them. Then I measured the muffler and mesured from the rear section to the long section and made a mark and cut at the mark and it fit pretty good after that. Just make sure the rear section is together right and the hump is over the axle where it should be before you cut.
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top