Dodge Cummins Diesel Forum banner

1 - 1 of 1 Posts

·
Registered
Joined
·
479 Posts
Discussion Starter #1
Ok so my carrier bearing/driveshft support bearing is toast, and I'm wanting to get the rear end up a little bit, so I was wondering if I cold use the whole bearing assembly and axle blocks from a 4wd on my 2wd?

I was in contact with a guy that used 2wd stuff on his 4wd for pulling his gooseneck, but that was a while back and I don't remember his name.
 
1 - 1 of 1 Posts
Top