[moose18]

i need help on this asap. got a 2011 dodge with a dpf delete and running a simulator, not a programmer. truck still did bad on fuel so we tried to put on a bullydog gt this evening that one of my workers had laying around. programer says it can run a 2011. so he tried downloading it onto the ecm and it didnt finish. my factory tune is gone apparently and it wont start. what can i do? tried disconnecting the battery cables and letting it reset, and nothing with the bullydog seems to work. help please

 

[dozer12216]

Perhaps a dealer can reflash/reload by serial number. Lesson learned??

 

[grporter]

Anyone near you have a smarty or h&s? Maybe attempt a load and go back to stock. I know the Smarty has a good recovery feature, just not sure if you're too far gone...

 

[moose18]

k got it fixed. the bullydog death flashed the ecm. dodge re-flashed it and took out the simulator that was in it. since the dpf was still out it was in limp mode. took it to walls hot rod close to winnipeg manitoba and did a full egr delete and a custom ecm and trans tune by walls. runs great now, gained around 5 mpgs and quite a bit of power. the guy at walls said 2011 has a new ecu and shouldnt be tuned with a handle held and cant run a simulator. would of been nice to know before but oh well. thanks for any comments or replies

 

[stanley91]

Your from winkler? Nice to see somebody that's only a couple hours away from me! Haha