Dodge Cummins Diesel Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
2,286 Posts
No, it is a self bleeding system.

You might open the water drain on the filter housing and bump the starter to see that the lift pump is pumping.

After my injector install, I did the bump the starter thing a few times and had to crank it for about 20 seconds. Then she fired right up.

You might recheck the torque on the connector tubes. That can keep it from building rail pressure and it won't start. Might also pull the electrical connectors on the fuel rail and check the pins. One could have got bent.

Randy
 
1 - 1 of 1 Posts
Top