Dodge Cummins Diesel Forum banner
  • Hey everyone! Enter your ride HERE to be a part of this month's Ride of the Month Challenge!

wiring

  1. 98.5-02 Performance Parts Discussion
    Installing my Airdog II-4g 100g/hr pump today... got the fuel sender modified, pump on the rail under bed, and went to wire it up while the transfer pump was putting fuel back in the tank. Got the pump plugged in, positive and ground hooked up, and went to clip the last piece together... aka the...
  2. 07.5 - 09 3rd Gen 6.7L Non-Powertrain
    Hey guys, I've been reading thread after thread trying to find out if someone had the same issue my 07.5 cummins is experiencing right now. Basically what happens is that as soon as I hit the ignition and the truck starts, the fron right parking lights and the rear left reverse light...
  3. 3rd Gen. Non-Powertrain
    Hey guys, I've run into a bit of a problem, I've searched for hours and hours I cant quite find the right info I need. So I have a 2007 Dodge ram 3500 Mega cab 4x4 auto. I wanted to manual swap it so I bought a 2006 ram 3500 quad cab long box that had a manual. My plan was to swap everything...
  4. 4th Gen Non-Powertrain
    So. Just joined the 6.7 fam. 2014 6.7 3500 SRW Limited. Hi đź‘‹. Love the truck, but I'm trying to track down some tech resources. The long and short of my issue is as follows: I smelled burning, electrical burning. Windows were intermittent. Sometimes front, sometimes rear. Now only the...
  5. 2003 & Early 2004 Only Discussion
    Hi, I recently bought a RAM and so I am new here. Having a cabine on the pickup and want to attach a B2B charge control. Now having the questions, is this alternator smart? Does this have an ignitation (d+) signal? Thanks for guiding. Any good documantation available for the wiring and...
  6. 98.5-02 Powertrain
    Hey guys, have a question about wiring harnesses on the vp44 24v trucks. I have a 2001, 2500 5spd that was a theft recovery but the wiring harness was melted and ruined. Ecm and pcm are presumably good (going to get tested). I picked up a complete wiring harness from a 1998 with an auto trans...
  7. 3rd Gen. Non-Powertrain
    I have an 04 Dodge Ram 2500 5.9L. I’m having issues with trailer lights. The left side of the trailer works perfect (Yellow wire from tipm). Light Green wire (which is for right side) is only getting .25 volts coming out of tipm. Upon further searching, I found that fuses 32-34 which is: 32...
  8. 07.5 - 09 3rd Gen 6.7 Liter General Discussion
    About a week ago I noticed my drivers rear door would not lock electronically on my 2009 3500 megacab srw. I have learned that it's common on these 3rd gen trucks and I plan on replacing the harness unless somebody knows a better way. This morning my wife went to start it and it lurched over...
  9. 89-93 Non-Powertrain
    Working on a 93' D250, Automatic. The Original "broom" and a number of the fuseable links went full send/meltdown with a side of smoke. Removed links and burned wiring and swapped in a Safety Hub 150... Not sure what caused multiple fuesable links to go (seemingly at once, or which one went...
  10. 89-93 Non-Powertrain
    Typical dodge wiring. I have a automatic 1991.5 W250. I just installed new speakers, and now I have some gauge issues. My engine temp and oil pressure gauges are consistently in the middle even when the truck is off. All other gauges don’t work. I don’t know if it’s related or not, but I also...
  11. 98.5-02 Powertrain
    1st post here.. if I did something wrong let me know! Anyways, truck ran fine when I left it. Then I had to get it shipped/trucked home. When it came off the lowboy, it was hard to start, then it wouldn’t start. I’m not getting power to VP, or my lift pump. Battery voltage reads 0. Wait to start...
Top