Search Results for ‘starter wont crank’

Have owned this 09 since it was new. An intermittent problem that I've always had has recently gotten worse. As my batteries get older I have a cranking issue. The batteries are still good but the starter begins to simply bump but the solenoid refuses to stay engaged. it's not a click but...

Just as the title says I have a 2003 4x4 manual with 260,000 miles, when I turn the key one bump it does everything like it normally would, turn the key to start and nothing happens. The dash acts as if the starter was in fact turning. I checked the fuses and my starter Solenoid fuse was blown...

Hi! I am new here and looking for some help. Get no starter crank when turning the key. I can crank it over by jumping the solenoid relay. Have replaced the starter, swapped the relay, jumpered the cluth saftey switch and replace the ignition key and module. Same problem no crank. Any...

I was having a reoccurring issue where I'd get a 'click' once a second when I attempted to turn the truck over... Sometimes the truck would turn over immediately, sometimes it could be a bit... Sometimes had to wait 10-15 minutes... but it would always start and I would always hear the...

My 08 Cummins 6.7 auto 68rfe trans, go to start and nothing from the starter, no click or sound, everything lights up and kick on except for when I go to crank it over Nada! I’ll wait a bit and try to turn over few times and bam outta nowhere it cranks over, put a new starter and still same...

So one day my starter seemed like it was taking a dive on me, I had to push start it to get back home from work because the starter wouldn't engage. There's no check engine light, I've rebuilt the solenoid, replaced the relay, checked all fuses and wiring, but it just won't turn over. The only...

Yes i've googled, and searched everywhere and can't seem to find anybody that has experienced this issue. Just did the G56 swap on my 2006 Dodge Ram 2500 Mega Cab 5.9, everything was swapped correctly without any issues. Wired up the clutch safety switch properly because when I try and turn the...