Dodge Cummins Diesel Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-6 of 6 Results
  1. 94-98 Powertrain
    Hello, I'm new to this site, however, I'm having an issue with my truck and I hope to get some help. Truck is a 1995 12 valve with the p7100 pump. Whenever I start the truck it fires right up and idles fine as long as you don't accelerate, but when I rev it up the rpms drop all the way down and...
  2. 98.5-02 Powertrain
    98.5 24v idles but when i apply throttle it misfires severely and wont rev past 1000-1200 rpm. After idling for a few minutes, it shuts off as if i removed the key. Changed the batteries and alternator and cleaned all grounds I could find. Same issue. Had some indications of bad ecm so I had...
  3. 3rd Gen. Non-Powertrain
    Hi, I am really looking for any help I can get. I have a 06 5.9 cummins g56 truck. I took it to a shop where I had a FASS system installed as well as a sump. I picked up the truck worked great, the previous lift pump was bad. Had all the power back rolling coal etc. Than as soon as I jumped...
  4. 94-98 Powertrain
    I recently bought this truck n I'm new to diesels. So when I bought it I had a hard time trying to get it going but once I got it warm it would crank good. I bought it in Houston so I drove it back.. 3 hours on the trip back it turned off on me when I would press on clutch but as soon as I would...
  5. 94-98 Non-Powertrain
    90% of the time this '96 Ram 3500 is driven up at around 4,000' in the Piute Mountains and it performs fine, but when I have to head down to town for supplies it often idles rough and stalls because it feels like the idle is too slow. Normally, I can live with it but I have a holiday drive...
  6. 94-98 Powertrain
    I recently purchased a 97 12 valve Cummins. When I hit the brakes in the slightest bit the truck starts to bog down and the engine pulses, and when I am stopped and press the brakes down a little more for a hill the truck stalls out. The truck also stalls when I go from stopped to about 1/4-1/2...
1-6 of 6 Results
Top