Dodge Cummins Diesel Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-11 of 11 Results
  1. 3rd Gen. Performance Parts Discussion
    I was wondering what the udc can do for the smarty s06. I have been reading up on it but I can’t find the answer I’m looking for. What can I adjust with it and can i adjust the fueling/ low boost fueling? Is their any major differences between udc pro and just normal udc? Thanks!
  2. 3rd Gen. Performance Parts Discussion
    I was wondering if you can get the older tnt non r tunes for the smarty s-06. If so how would I go about getting ahold of the older files. Thanks.
  3. 3rd Gen. Performance Parts Discussion
    Hey im wondering if I anyone can give me a direct answer because I can’t find it anywhere on the internet. I have a 2007 5.9 with a smarty touch. I know rail pressure and torque management levels go in order 0,1,2,3. I have read a lot of different things on timing from 2 being the most advanced...
  4. 3rd Gen. Powertrain
    2007 cummins 5.9 g56 bag of parts, new Bosch injectors, fass 165, studs, straight pipe, air intake, smarty touch w/ egt probe near cylinder 4, sw5 w/timing, wastegate off and see 37 pounds of boost My truck will idle at about what everyone else’s trucks idle at 150-300, I have seen a few even...
  5. 3rd Gen. Powertrain
    Pretty much finished my last step of the swap today. The tuning. For me I bought a Smarty Jr. then contacted Smarty and they had a auto to manual recover written for it. I downloaded SmartyUDC, then they email me the file, I plug the Smarty into the computer via a simple printer cable that’s $6...
  6. 98.5-02 Performance Parts Discussion
    I have recently got a smarty S-03 Tuner for my truck. (2002 Dodge ram 2500 6 speed). My truck is all stock except the air intake. My question is, is it safe to run these tunes on a stock truck? If yes, up to which stage is recommended to run on a stock truck? My truck has recently been acting...
  7. 3rd Gen. Performance Parts Discussion
    I do not know if this is the right place to post this or not but I have a smarty with my truck never had any issues I own a 2004 Dodge Ram 2500 it loads every time and works as it should well I’m trying to sell mine and get a newer so I returned it back to stock and a guy came over to buy he...
  8. 4th Gen Performance Parts Discussion
    So I bought a 2014 2500 dodge that had been deleted before. I bought it with the monitor screen missing. The wire is still there and the truck is still deleted. The guy that owned it before said it was a smarty programmer but he took the screen off and sold it. What do I need to do to get a new...
  9. 3rd Gen. Performance Parts Discussion
    04 cummins with edge attitude monitor (older grey style) on stock running smarty s06 pod with TNT-R sw1. Just recently switched from REVO sw7. Now my egts are acting crazy. Goes from 300° at idle and steady/quickly climbs to 1800° within 10 miles while doing 55mph empty!!! 😳 (i have my alarm...
  10. 3rd Gen. Performance Parts Discussion
    Hi, I have a 2004.5 2500 Cummins with the It’s bone stick with a straight pipe. I recently bought a brand new smarty touch tuner and I got it all hooked up and I can’t get it to tune my truck. When I hit the ecm button to go to where I would tune it, it pops up an error and says “ecm not in...
1-11 of 11 Results
Top