Search Results for ‘sensor’

I have a 1998, 5.9 cummins. My crankshaft position sensor finally bit the dust and in attempts to replace the sensor, it broke off halfway leaving it stuck in the block and I am unable to get it out, I have tried self tappers and bolts inside of the sensor and none of that seems to be working I...

Yesterday on my way to the trails, my coolant low light came on. I could see it in resivor but it was at the bottom. I topped it off and the light never turned off, got to the trails and rode for 5 hours and started it up and it was gone. Started driving home with the trailer loaded down and...

So got this 03 5.9 cr has bulldog gt tuner single disc tc and billet input shaft drove for 2 and half weeks daily no issues or any problems at all but it was running on 1 battery the other was disconnected and had lots and lots of corrosion got it all cleaned off put a new battery in drive...

Was installing my new exhaust and while I was hitting the cross member down with a hammer, I clipped the sensor plug and it broke. What is the name of this sensor? Located by the down pipe on passenger side.

Did a search and couldn't find exactly what I am experiencing. Sorry if this is in the wrong spot or has been asked a million times. Was having a coolant temp issue so changed sensor and thermostat. Now My coolant temp is reading all over the place constantly. Always bouncing around. It shows...

Hey all, I own a 2008 3500 cummins, with the G56 4x4. Recently been fighting with my AC system and have fixed all the leaks that had been going on, pretty much 95% of the AC system has been replaced ( condenser, evaporator, compressor, accumulator and orfice). The last issue I am having that...

Good day I have a 01 24valve 6speed I don’t know if this is considered power train but probably because it involves fuel. I have the old edge juice with attitude like the grey one, and the fuel pressure sensor hasn’t worked ever since I got the truck. It’s constantly reading 33psi no matter if...

Long story short a shop replaced the engine coolant sensor cause it was leaking when it went in for trans work. Ever since the sensor has been reading 60 degrees cooler than it actually is. So around operating it reads 125 degrees. From my understanding 03 has a different sensor than the years...

Hi everyone this is my very first post. I have a 2000 dodge 5.9 Cummins 5 speed. I'm having issues with the map sensor. I get codes p0237 p0236 Low cricut so, I bought a Cummins map sensor that didn't fix it. I followed moparman's post about disconnecting map sensor and Ecm to see if there is...

Hey guys, I have a 2002 Dodge Ram Cummins, 6 speed. My truck has been acting up. When I'm driving, the truck is cutting out on me from time to time, leading it to actually cutting out completely and dying. The truck starts right back up every time. Almost seems like a short of some sort? Maybe a...

I have a cold air intake off of a 6.7 2007 Cummins. I bought it off a wrecked truck for cheap so I didn’t look into it too much. That’s my mistake, everything looked like it would fit correctly until it came time to put the sensor in mine is a 2006 5.9. My question is does anytime know of an...

Just a heads up on replacing your Crank/Cam sensor. First off might wanna pull your crank sensor and check it. When I was down there I noticed it was worn pretty badly, I assume from grit getting slung across it for 15 years. I’ll post a picture in a bit. I had two sensors on hand I bought as a...

Finally after 9 years my OEM from-the-factory sensors died. Well, three of them. MORESENSOR TPMS sensors were about 1/3 of the price of MoparPartsGiant. I knew it would be a risk, but wondered if these TPMS sensors for sale on Amazon would: be EASY to install? even WORK? would they AUTOLEARN...

I installed the S&B on my '14 3500 Limited. Other than getting the motor out of the stock air box & breaking the TMAP sensor, it went well. I replaced the sensor & since then, my Raceme Ultra & stock gauges are reading 5 psi of boost at idle. The sensor that I used as a replacement is cheap...

Just replaced top cp3 from ATS twin fueler kit since old one decided to shred itself. Put new cp3 in and hooked up all correct lines and plugs for FCA/FR-PS. Primed system 4 times and cranked it over. Started up really rough with a giant chop. Eventually turned itself off after chopping for a...

Hey guys, 2008 ram 3500 6.7L Maybe y'all can point me in the right direction. My truck has had some AC issues in the past, which I took care of by replacing some parts. I had to do a service on the AC and ran through the usual vacuum and recharge and my pressures are doing alright, around 32 low...

Any 1 kno how much it costs to get a new airbag sensor? I’m looking @ a 2nd gen it has a few issues. 1 of which is the airbag light is on. 🤷🏼‍♂️ Just wanted to get an idea as to how much it was projected to change out myself VS hiring a shop 2 do it

Are these two nox sensors the same part number? all the research I've done will not answer this question for me. Basically if I need to replace both... are both sensors part number 68210084AA ???

My serpentine belt blew apart on my 04.5. When it did that it took out my crank position sensor and fan clutch. The truck can drive me to work without a fan so I ordered one. But it would hardlystart with the p0335 I think it was. I Replaced the sensor and now I'm getting p0336. The sensor...