Dodge Cummins Diesel Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-9 of 9 Results
  1. 2013-2018 Non-Powertrain
    I have a 2012 2500 Big Horn with around 250k and it recently started having a very faint squeaking heard in the cab mostly while turning, as far as I can tell it does not matter if its left or right. I recently lubed everything aside from the double u-joint connection because I still cant find...
  2. 3rd Gen. Powertrain
    I have a whining noise that happens when the torque converter locks up usually exactly at 80kmh(50mph) and it will go away when I speed up around 90kmh and then comes back the loudest when I decelerate back to 80 until the torque converter unlocks. Goes away if you put it in neutral also. This...
  3. 3rd Gen. Non-Powertrain
    Hello, I have a 2005 Ram 3500 diesel with an automatic tranny and around 194,000 miles. I am the second owner and the Ram is all stock. At 70 to 75 mph I hear a squeek from the engine compartment that sounds like a belt squeak. I have changed out the serpentine belt and the tensioner pulley...
  4. 2013-2018 Non-Powertrain
    Hello folks, Hoping this is a simple fix. I just purchased my truck a couple weeks ago and have noticed a lot of clanking noises from the front driver side area ;suspension sounds). Upon investigation, I found that the BD steering brace is contacting my sway bar. The contact point is at the...
  5. 2010-2012 Powertrain
    Hey y’all I have a problem I need to sort out because so far everyone I’ve talked to seems to have a different answer or no solution at all. I have a 2012 3/4 ton and there’s been two problems ever since 2g swapping plus putting new tunes on. Problem one started after the swap and it’s after 20...
  6. 3rd Gen. Powertrain
    Recently I posted a thread about how my truck exhaust would make a chugging noise at idle, but recently I’ve noticed it’s running very hazy especially when it’s cold, this morning was about 65 degrees outside and it blew whiteish grey smoke at startup and ran very hazy for the first pull up the...
  7. 2010-2012 Non-Powertrain
    Hey y’all, I saw a few videos of some older 2nd Gens that right when they shifted there was a loud turbo bark (suction noise). This isn’t like the typical 5.9 flutter you hear after letting off the gas. Looked at the comments and people were saying it was called a “pente na turbina” mod because...
  8. 07.5 - 09 3rd Gen 6.7L Powertrain
    So today when I got to work, I went to back into a spot and noticed a weird rattling/clunking noise. The noise continued as long as I stayed in reverse. In drive, it disappeared. No noise in park or neutral either. Fast forward to my break 4 hours later, noise totally disappeared. Good enough...
  9. 2010-2012 General Discussion
    Bought a 2011 Ram 5500 chassis cab a while ago for a good deal because it was knocking. I did a injector test where I disconnected a wire from each injector one by one and ran the truck. The results were that the knock went away almost entirely from disconnecting injector #6. In hopes of this I...
1-9 of 9 Results
Top