Dodge Cummins Diesel Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-9 of 9 Results
  1. 3rd Gen. Powertrain
    Cold start problems I got a 2006 5.9 Cummins was an auto i manual swapped it. no tune just plugged in the sensor above the shifter so I can have full power for now. I have the Neutral wire wired to the ground on the battery but the truck will only crank if I go from off to start really quick I...
  2. 94-98 Powertrain
    Wanting to swap a zf5 into my 1996 12v besides the adapter plate what all will I need? (drive shafts, transfercase adapter, can I use the pedal assembly from the for or the dodge one?, also what years are interchangeable?) have a lead on a one out of a 1989 f350 with a 7.3
  3. 3rd Gen. Powertrain
    Hey guys..just picked up a gourgous 05 auto and used to own a 99 with the 6 speed and am wanting to replicate that running gear in my 3rd gen.. anyone know where to start at finding the parts needed. I live in northern idaho.. thanks for any and all help..
  4. 3rd Gen. Non-Powertrain
    Hello all! BLUF (Bottom line up front): I have an automatic 2005 Dodge Ram 3500 2WD that had it's automatic transmission swapped for an NV5600. The ECM is still an automatic... Therefore, it has 7 CEL codes that triggers "limp mode" characteristics (cannot rev past 2000 RPM in neutral or in...
  5. 94-98 Powertrain
    Hey everyone I am considering doing a manual swap in my 1998 dodge 3500 12v Cummins. The things a tank but the trans is starting to go and have wanted a manual cummins for a while. Im wondering what parts Id need and a rough run down of what id need to do. Im looking more into a 5 speed but...
  6. 07.5 - 09 3rd Gen 6.7L Powertrain
    Hi! I live in Norway and have a 08 Ram 2500 6,7 with the rfe68 transmission. As far as I know this is the only 08 2500 in Norway, so it's a somewhat special car over here. I love the truck, but hate the rfe68 trans. So I am looking for all the parts I need to perform an auto to manual swap...
  7. 3rd Gen. Powertrain
    I recently swapped my 48re for a 5600, has anyone had any luck getting the truck to shift into 4low? 4Hi works fine. I’ve searched and haven’t found anything. Truck is a 2006 with a electric shift transfer case of course
  8. 98.5-02 Powertrain
    Hi all, I picked up a 7 speed Eaton w/OD TX-8607B. It’s going in a 2002 3500 24v 4x4 auto. I have most things sorted as far as a bellhousing, flywheel and clutch. Then I’m getting a hand from a local driveline shop for the T-case and shafts. The only thing now would be the clutch linkage and...
1-9 of 9 Results
Top