Cummins Diesel Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-4 of 4 Results
  1. 03-07 Performance Parts Discussion
    I have an 05 Cummins and I recently picked up a Smeding s369 turbo and once I installed it the exhaust elbow was quickly realized to be too long and hits the dip stick tube as well as the firewall. Are there any remedy’s out there to resolve this? It almost seems like the elbow has to be shorter
  2. 98.5-02 Non-Powertrain
    Probably beating a dead horse but I've looked but haven't found anyone with a similar issue. Im having troubles installing a Cts 3 that I was going to pick up from a buddy. It has been in a few trucks before and worked fine but whenever I plug it into my OBD 2 port the monitor doesn't read my...
  3. General Diesel Discussion
    This short crane will tuck out of the way over a rear wheel well and has a max lifting capacity of 1,000 lbs. but it is advised by the manufacturer to bolt the base to a frame member as the bed floor will likely warp or tear under the stress. So far as I know there is no frame member under the...
  4. Bully Dog install 2

    Bully Dog power wire through firewall - location which I found easiest.
    Image uploading. Refresh page to view
1-4 of 4 Results
Top