Search Results for ‘help’

Hey, i got a 2012 dodge ram 3500. i just got this truck a week ago and it started overheating the other day on the highway, i was doing about 70 and wasn’t on it. the temp shot up to 240, it came back down to 210ish while at idle, as i got back on the highway the temp started to crawl back up i...

Hey, i got a 2012 dodge ram 3500. i just got this truck a week ago and it started overheating today on the highway, i was doing about 70 and wasn’t on it. the temp shot up to 240 so i pulled over let it cool down and fan kicked on and everything it came back down to 210ish, as i got back on the...

I have a 2012 2500 6.7 Cummins. It’s bottom end it blown it shot a piston out the side of the block. I found a new engine out of a 2012 3500 Cummins. I’m hoping to just switch the bottom ends out and leave the top end. Are there any faults in this? Also the engines are exactly the same from a...

I rebuild my 5.9 12v took it apart in late December didn’t get the parts back mid February n between lagging it and some things I ran into we are here. I think I got everything where it belongs but I ran in to 2 wires that I have no idea where they go I think they hook up to the battery but I...

I have a 2005 5.9 truck has a smarty touch 4” exhaust cold air intake horn with a airdog 150 w/ beans sump I have a PO251 code won’t always come on but it always clear for awhile along with a ding of 9 times with the a wait to start light cp3 and injectors where done 24,000 miles ago Fca...

I have a 2009 6.7 with a manual trans and it has been deleted since I bought it. At the current moment my county I live in does not have emissions requirements but I have a feeling that could change within the next couple of years so I was wondering if there were any options that would allow me...

Hey guys, I’ve been battling an issue with my 98.5 24v 4x4 first start up it high revs up to about 2000-2500rpms only in park and neutral, in drive it idles around 1200-1500 and I have no throttle response, if the trucks been sitting awhile every now and then it won’t do this, however, it...

Hey guys need help as I am stumped I have a soild lighting bolt light and will make boost for like 2 seconds then cut and barely let’s me get to 60 very slow I was on a 5hr drive it was good tell I stopped to get diesel left truck running jumped back in and the light was on with no power truck...

So got this 03 5.9 cr has bulldog gt tuner single disc tc and billet input shaft drove for 2 and half weeks daily no issues or any problems at all but it was running on 1 battery the other was disconnected and had lots and lots of corrosion got it all cleaned off put a new battery in drive...

So got this 03 5.9 cr has bulldog gt tuner single disc tc and billet input shaft drove for 2 and half weeks daily no issues or any problems at all but it was running on 1 battery the other was disconnected and had lots and lots of corrosion got it all cleaned off put a new battery in drive...

I want to make a 2 piece exhaust manifold 3 cylinders each manifold. Will have stainless steel flanges and piping to individual t4 flanges also stainless. Then you stick two hx35s on there and also make a exhaust piping to go from the dual turbos not compound … dual turbos. That become a...

So… truck came “tuned”, I just got my quadzilla & obviously I need the truck flashed back to stock. After the dealer tried to flash the truck they told me that “the truck had a burner tuned PCM where it was shipped out, tuned & sent back, not just a normal OBD tune”. Is my only option now to get...

I’m looking for what fuse or fuses would be connected to my gauge cluster. I’ve got a 1995 Dodge Ram 12 valve. Thank you and I appreciate any response!!

Hello, I’ve recently installed a MPC Remote start on my 2006 Cummins and have had a reoccurring issue. What happens is that activate the remote start and the truck starts, and after a few seconds the truck dies. The remote start then reactivates on its own to start the truck and it runs...

2005 Ram 2500 5.9 - 137K Miles Over the summer of 2022, my 2nd gear went out. We decided to do the rebuild ourselves. Since the transmission was going to be out, we decided to do some upgrades while it was out, listed below: Upgraded 2nd gear band New 2nd gear drum All new clutches and spacer...

Ok I hate to ask I almost always figure it out but I’ve dumped every dollar in to this truck trying to get a good work truck to haul my equipment. Ok so I got a 1999 dodge 2500 4x4 auto with 1 ton running gear that I put a p7100 pump on it and the first pump was a 180 pump. I did the conversion...

Hi, this is my first post on the Cummins forum and probably any forum! So I apologize in advance if I am doing anything incorrectly. I just finished doing a slight overhaul of my 1994 Dodge 12 Valve Cummins engine and I can not get my injectors to stop leaking. I've already read through many...

Hey, I've recently purchased a 2001 Dodge. I have read almost every post I could find to try and answer my questions but I still can not find the information I am looking for. I have worked on cars a lot but this is my first venture into the diesel world. I did the oil cap test when I first...

so my brakes have always been spongy, and i had a blown passenger rear cylinder which ive replaced awhile back. Yesterday i was driving in the rain and noticed a big decrease in stopping power. I had to put the pedal to the floor, and the BRAKE and ABS light would come on. I got home and checked...

alright i just installed a new transmission from tier 1 Transmission good up to 650hp and a Hamilton cam with springs pushrods and head studs i also have an air dog 165 and bosh 505 injectors with smarty so6 tuner on 35" tires . Now I'm in the market for an exhaust manifold been looking at the...