fuel filter

Will the front fuel canister seal without a fuel filter in it? I am looking to add an additional cat fuel filter in the rear near the stock WIF filter. Can I just take the stock front fuel filter out of the canister and still get it to seal shut? I want the fuel heater on both the front and rear...

Hi everyone, I have a flatbed towtruck with a 2017 ram Cummins 6.7. Randomly while driving the engine will cut off. All electronics stay working. Happens once a week or so. I have to sit there and crank the engine for several minutes (like a fuel pump) then it will start up and drive like...

Bought my truck used with 40,000 miles and the dealer said they done a full service. 3 months later I do my scheduled maintenance and I change my oil and fuel filters. I pull the underhood paper filter and its covered in dark gray soft never sieze consistency material. Its not hard at all and...

My first project on the truck was putting a premium fuel filter kit on. I heard a lot about issues from wear and the expense that job costs. So I researched and found this aftermarket fuel filter kit: Diesel Fuel Filter Kit Took about 2 hours maybe, quite intimidating to be cutting into fuel...

So recently bought myself a 2001 2500 24v after doing alot of searching, im looking to upgrade my fuel system like fuel filter and lift pump, but confused on what the difference is or if there is one?! 355*km From what i know from the previous owner is the pump has been changed, injectors have...

Hi all-- Recently inherited a 2011 6.7 from my father. It has around 105,000 miles on it. Long story short: Pops didn't change the fuel filter enough. He took excellent care of the truck regardless but the initial filter wasn't changed until way too late. Truck threw a fuel rail sensor. I...

Hello All, 2016 Ram 3500 6.7 Cummings Fuel Filter (both WIX) and Oil/ Filter Change Changed the oil and the fuel filters. Attempted to start and just one click of the starter, I had a leak in the driver side housing- (bad O-Ring seat). Removed and replaced o-ring, tightened everything back up...