Dodge Cummins Diesel Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-6 of 6 Results
  1. 3rd Gen. Powertrain
    Hey everyone, Just put a Carli Commuter 2.0 on and replaced the axle shaft seals while the front end was dropped. Immediately after the test drive it was fine, drove it on I-5 about 10 minutes to my house and parked it and a good puddle of gear oil was under the passenger side. Dropped and...
  2. 3rd Gen. Non-Powertrain
    Hey Everyone, I’m about to put a Carli Commuter 2.0 kit on my 06 2500. I noticed a few weeks ago my driver side front end is making a really bad ticking. Almost thought I had a rock stuck in my tire but I put it on a lift and noticed that every time I rotate the tire 180° the axle shaft drops a...
  3. 2010-2012 Powertrain
    Hello everyone, so recently I installed a thuren 3” kit with shocks and track bar. While doing so I realized my ball joints were worn so I replaced them with EMF ball joints and did axle Ujoints as well.buttoned everything up and got an alignment but I’m having a grinding feeling every now and...
  4. 3rd Gen. Non-Powertrain
    So I basically inherited this 03 2500 SLT 5.9 2wd Ram. It is sagging in the front so I am looking to put new coils, shocks, and a lift/level but- I am having issues identifying the front differential for the right parts AND.... There ain't a front diff to be found!! Is this a solid axle...
  5. 03 - 07 3rd Gen 5.9 Liter General Discussion
    Hey guys, I was wondering if anyone would have a pair of oem stock front coil springs for a 2006 Dodge Ram 2500 ? Currently have a 3 In Carli lift and want to go back to stock
  6. 3rd Gen. Powertrain
    Im going to be replacing my brakes next week and wanted to do my front axle U-joints at the same time Should I go with Spicer or Yukon parts? What is the part number for the correct ones?
1-6 of 6 Results
Top