Dodge Cummins Diesel Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-19 of 49 Results
  1. 98.5-02 Performance Parts Discussion
    I have a edge comp box for a 2000 Dodge Ram 2500. I do not have a wiring harness for it and I contacted edge trying to order a new harness, which I was told they don’t make anymore since my tuner is manufactured in 2005. Will a newer harness work, or if someone could help me find a new harness...
  2. 98.5-02 Performance Parts Discussion
    I'm not entirely sure if anyone else has encountered this issue but I am having a problem getting this part off of the mainshaft of my NV4500, anyone have any ideas of what this is or how I would get it off or if it even comes off?
  3. 07.5 - 09 3rd Gen 6.7L Non-Powertrain
    So i bought this truck about a year and a half ago. ever since ive owned it my exhaust brake and speedo along with odometer have never worked. i never really payed attention to it since it was a bit of a project, with a ton of codes and alot of stuff to be done to it. Since then ive basicly...
  4. 98.5-02 Powertrain
    1999 Dodge Ram 2500 Cummins 4x4 My truck didn’t want to pull back to 4wd high so I pushed the lever forward to neutral and to 4wd low, now it is stuck there and the lever will not pull back, checked fluid level and level was full, drained fluid and put in New atf4 and lever will still not pull...
  5. 07.5 - 09 3rd Gen 6.7L Powertrain
    Hey guys got a question... 08 ram 2500 68rfe. Rebuilt trans has revmax high performance alto red kit new sensors all around new solenoid block and a ats diesel anodized valvebody with thicker separator plate and gaskets... truck will shift 123454564 then usually stuck in 4 (limp mode). Line...
  6. 03 - 07 3rd Gen 5.9 Liter General Discussion
    Hi everyone, brand new here and first post on here. I’ve been reading into tons of posts from 1st gen to 5th gen but decided 3rd gen would be the right fit for me. Only issue is where I live they are few and far between. Either high mileage with light rust. Or low mileage with lots of rust...
  7. Tire and Wheel 3rd Gen
    Looking for some help in figure out the biggest size tires I can fit on here. I just bought the truck and it needs new tires shortly. it has a 3 inch lift and the tires currently are 33x12.50x20 Wondering what the specs would be. Thanks in advanced
  8. 03 - 07 3rd Gen 5.9 Liter General Discussion
    I've been on this issue on my father's ram 3500 2007 diesel for around 2 years now. Here's more info so i can provide you more of an idea; codes, model#, etc. 2007 Dodge Ram 3500 _ SLT 4D_ Diesel L6, 5.9L;High Output;Turbo Code(s): Confirmed(P2509) ECM/PCM Power Input Signal Intermittent...
  9. 2013-2018 General Discussion
    I have a 2015 Dodge mega cab dually and would like to tow my 18 foot boat behind a fifth wheel. Does anyone know the largest fifth wheel I can get with this combination to not exceed the 65 foot rule?
  10. 3rd Gen. Powertrain
    Recently did an overhaul on my 5.9 Cummins. Everything went smoothly and had no problems assembling. Before dropping the pistons in I checked each ring gap and everything was perfectly in spec. Only put brand new parts into the engine... nothing was reused. Truck started right up on its first...
  11. 2010-2012 Non-Powertrain
    I have a 2012 6.7 Cummins. The truck Idles crazy! When I start the truck it runs fine for about 15 seconds then starts to get choppy. I replaced the FCA with the Bosch replacement (ORiellys and dodge want 3x the amount for the new brand). I also replaced the pigtail and connector as the...
  12. 2010-2012 General Discussion
    Hey y’all, quick question. I knew Ram split off from the Dodge name in 2009/2010. My question is, my 2012 2500 has “DODGE” emboldened on the original center console. Any reason as to why this would be on there if it’s just a Ram? Thanks!
  13. 3rd Gen. Powertrain
    New to my truck, bought it month ago. Injection pump the bed. Replaced pump and injectors(used but working) everything is to torque. Have fuel at the injector line. Truck will not fire . Gave it a Sniff of ether(grid heater disabled) just a quick 2 sec burst. Just to see if it would cug...
  14. 98.5-02 Performance Parts Discussion
    I’m new to cummins so sorry I’m going to sound stupid. I’m trying to build my stock second gen other then a 50hp chip and a aftermarket air intake and exhaust system, to be able to produce 450-500 hp without any headstuds or anything, I know any more then that I’ll need headstuds, I’ve been...
  15. 07.5 - 09 3rd Gen 6.7L Powertrain
    i have a 2007.5 dodge ram 6.7 that i recently replaced injection pump as their was metal in the fuel filter as the truck was spluttering and poping and idleing rough also hesitating when steeping on throttle which the new pump fixed kinda the engine still somtimes on and off will shake bad...
  16. 2013-2018 Powertrain
    Truck is a 2015 2500 outdoorsman. It has been deleted for about 6,000 miles and tuned by ecofreak custom tuning and have had zero issues with it. The stock 68 went out. I had been doing research on the g56 swap for a while now and it looked doable. Found a salvage yard that was selling a g56...
  17. 3rd Gen. Non-Powertrain
    I have a 2004 cummins, recently I replaced the headlights to aftermarket LED. the installation went well no issues everything worked. I then added a light bar, during the adventure through the firewall for the switch I used a knife to poke a hole in one of the rubber seals. the light bar worked...
  18. 3rd Gen. Non-Powertrain
    Hey guys. I'm new here. I did a lot of looking around the forum, and have found a lot of great information.I am currently looking for a Dodge/Ram truck with the Cummins Diesel. I've always had Ford trucks before, and my last was a 2000 F250 SD with the 7.3L PS and a 6 spd. It was a beast, but I...
1-19 of 49 Results
Top