Dodge Cummins Diesel Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-8 of 8 Results
  1. 3rd Gen. Non-Powertrain
    2 days ago, I took off my muffler on my 2006 2500 with the common rail 24v, just this evening it threw a check engine light and starting running absolutely terribly, codes pulled were P0606 - internal control processor AKA the death code, P2146 - fuel injector group 1 supply voltage...
  2. 2013-2018 Non-Powertrain
    I have a 2017 Ram 3500 drw limited fully loaded with dual alternators and one alternator is putting out almost zero volts; While the other is putting out 14.6 I noticed this because my battery voltage gauge would read 13 instead of 14 so I decided to check. After getting a test with it on the...
  3. 2010-2012 General Discussion
    I have a 2011 3500 fully deleted with the H&S Mini maxx long story short truck started runnin hot so I replaced the thermostat. The problem continued so I’ve ended up replacing the water pump and fan clutch and the truck is still running hot. Probably gonna flush radiator tomorrow…. Again all...
  4. 2010-2012 Non-Powertrain
    I've never seen this notice until a week ago. PO deleted everything before I got it. Stock otherwise. Raceme Ultra tuner set to stock parameters. No increases in timing, etc. Out of nowhere about a week ago after stopping at a red light, the truck "missed" and the diesel message flashed up...
  5. 07.5 - 09 3rd Gen 6.7L Powertrain
    This truck has got me stumped, I’m having a few issues and would appreciate any insight! So if I start the truck and drive it when the engine temp is below 100 degrees( pretty much when I get in and go) I will get a big puff of white smoke only if I get on the throttle hard( like floor it) it...
  6. 2019+ General Discussion
    Hey y’all, I know with pretty much each generation the Cummins engines have gotten increasingly quieter. However, I just saw a video with a 2019 that had a full delete + tune with a 5 inch straight pipe and it sounded almost completely stock. How has Cummins achieved this and could we ever...
  7. 4th Gen Cab & Chassis
    Hey guys, I have a 2013 ram 5500 with a chelsea pto kit. I recently deleted the truck and now my pto no longer works, I went into dash and everything is as it should, regarding pto. Is it possible the pto is not written in the tune? Any help would be great, thank you. -Dale
  8. 2019+ Performance Parts Discussion
    Hey everyone, so I am deleting my 2019 and having issues finding tuners that work on 2019. I haven’t called the companies to get more details. Wondering what you deleted guys are doing out there and is it pretty forward on deleting these new things (previous truck was a 08 6.7)? Thanks
1-8 of 8 Results
Top