Search Results for ‘cummins 24v’

4 doors more wh0res

i have a 2012 6.7 cummins with what i believe has the stock 68 RFE but my trans temp runs about 74-90 and i see a lot of other people are running 160+. just wondering if maybe i have a built transmission and don’t know it? any thoughts? shifts real smooth and the old owner didn’t say anything...

So it all started yesterday my check Guages came on I had no voltage. I was on my way from FL to Ga. I rode it out until it stopped had no power. I shut truck off popped the hood. Smoke was coming out my second battery passenger side. I unplugged battery truck started! 15 minutes later same...

Hey, got a 2012 6.7 High output cummins. Currently has 4 inch straight pipe and cold air intake. Looking for some mods that will help performance and not break the bank. Love sound of a second gen swap but I’m looking for some more affordable mods.

I have a 2012 2500 that has been acting strange. I went for a drive today and it started overheating and blowing cold air (while the cab heat was on high, full blast). I know that's due to it losing coolant, so I pulled it in the garage and turned it off, coolant poured out. Though it wasn't...

So I have a 02 cummins, Auto trans. I’m having issues. Blew the fusible link, luckily didn’t overcharge my batteries, but, I replaced both batteries, alternator, cam sensor, battery clamps, cleaned my grounds, throttle position sensor, and the speed sensor in transmission. I still have no...

Ive had the tuner for about 2 years now initially i had an issue with downloading the regular stock, tow, street, performance Tune figured it out after a minute or two. But recently i put in headstuds and put a lift pump and people were telling me to go ahead and unlock the trans tune on it so i...

Okay, so I was driving down the highway and out of nowhere I lost power to the trans and the engine was spitting and sputtering, from there on I got it to the side of the road and it died I got it start one more time it ran horribly and still had no trans. Now at home all it does is just crank...

I have a 2008 ram 2500 6.7 cummins, about a month ago the a/c stopped working. Only blowing hot air. I thought it was low on Freon but I noticed the compressor was off, so I checked the compressor for resistance and it read 3.5 ohms which is good, then I checked the power source (wire harness)...

Hallo,I am happy owner of 2006 5.9 .Winter time I had long crank to start unless plugged in.Later on year it got progressively worst and crank time extended to point of using starting fluid to start.No codes other than overboost and fuel delivery.Ive changed fuel pump in tank to dual fleece 150...

Hello all this is my first post, I had my 53 block crack beyond repair at 188k miles. I have found a 2001 freight liner 24 valve non-53 block for 2k. I was wondering if it would still work? The guy that has it doesn’t seem to know everything about diesels (neither do I) so I’m at a loss. Would...

I have a whining noise that happens when the torque converter locks up usually exactly at 80kmh(50mph) and it will go away when I speed up around 90kmh and then comes back the loudest when I decelerate back to 80 until the torque converter unlocks. Goes away if you put it in neutral also. This...

I bought a 1999 Dodge Ram 2500 Cummins 5.9l 24v Extended Cab and I have some questions if anyone could help me. 1. Would a s&b cold air intake be a good choice for a upgrade instead of the original stock one. 2. If I were to upgrade from the stock turbo, what should i look for? I dont really...

Hello. I have a 2001 non 53 block 5 speed truck. After a ton of countless hours and miles on the truck and it doing what I needed pulling a trailer every day it finally shot it. I pulled the engine apart and 5 of 6 cylinders all had broken rings. So therefore I thought I found the issue. Before...

Hi, I have a 2001 Dodge 2500 cummins. It currently has a 47re trans and i'm swapping that to a NV4500 5 speed. I was wondering if anyone has had to switch their VP44 to the manual option. I believe it is considered the HO VP44. The reason why i'm asking is because I added a bunch of aftermarket...

Wrecked my truck a while back and I have all the parts ready to fix everything, besides the intercooler and rad are backordered from mishimoto and they are claiming mid to late March, because of the ships being held up at the ports. I’m considering getting something different have any of y’all...

Hello everyone, just wanted to introduce ourselves (Auto Computer Specialist) and give a little background us and what we do. We are based out of Florida with over 30 years of experience. We specialize in Light, Medium and Heavy Diesel Computers (ALL Generations of Cummins, Powerstroke and...

2001 5.9 with a p pump swap. But metallic sounds coming from engine. Only at above 1100 rpm. I’ve heard of tq converter bolts coming loose and scraping the transmission. But has anyone had that happen before? Before I start tearing into the block😅

Hey y’all I got a question about my 02 Cummins, the Fan clutch got all bent up in a wreck and I’m now looking for a replacement, I cannot seem to find any oem ones anymore. Everyone says aftermarket fan clutches are garbage. So my options are to try to locate an oem one at a junk yard or...

Hey y’all I got a question about my 02 Cummins, the Fan clutch got all bent up in a wreck and I’m now looking for a replacement, I cannot seem to find any oem ones anymore. Everyone says aftermarket fan clutches are garbage. So my options are to try to locate an oem one at a junk yard or...