Cummins Diesel Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-12 of 12 Results
  1. 94-98 Non-Powertrain
    My 1997 Cruise Control stopped working after I replaced the seal on the vacuum pump / Power steering pump on the driver side of the engine. The cruise control, and heater-air conditioner control panel are vacuum operated. The control panel worked but not cruise control. I wanted to trace the...
  2. 2010-2012 Non-Powertrain
    I recently bought a ram 2500 6.7 Cummins after owning a 5.9 for years and never having any trouble. This truck seems to work like a dream but I have been chasing a nagging issue. The cruise control does not work. I have replaced the witch and brake switch (with OE parts) thinking that might be...
  3. 89-93 Non-Powertrain
    Hello. I've discovered that my cruise control will work only until the engine warms up; then it won't engage. I checked the vacuum level at the servo and have discovered that, when the engine is cool (approx. 90 degrees, given today's weather temperature) the vacuum reads about 4 inches on the...
  4. 2010-2012 Powertrain
    Has anyone else had a problem with cruise control going WOT and blowing out 5th-6th gear clutch? Twice within a month now and it's getting expensive. Truck is 2010 mega cab on 35x12.5 22 First time it was while towing my 5th wheel figured it was my fault from having the SOTF knob on 5 coming...
  5. 98.5-02 Non-Powertrain
    I know, I know, check the vacuum lines. I did, they’re fine. Let me explain. I’m working on my 1998.5 ram 2500 dually 4x4 auto (yes, a 2500 dually, someone swapped it) trying to get cruise control to work. I cannot get a cruise control light to come on. when I cycle the key on, the cruise...
  6. 07.5 - 09 6.7L Non-Powertrain
    So a couple years ago I was traveling in Texas and had right front hub go bad, met a great mechanic that replaced the hub with new sensor. Last year the left front hub needed to be replaced so I got er done (came with a new sensor). All worked fine for some time then lights came on and list all...
  7. 98.5-02 Non-Powertrain
    1998.5 24v 5.9 cummins. Cruise control will work here and there but not all the time. One time I got it work by pulling my brake pedal up. I have no light for cruise even when it does work! Driving home soon and need it work soon 2400 miles is a lot to drive with no cruise
  8. 98.5-02 Non-Powertrain
    Hello, 2002 5.9 24v, 6 wire throttle in a freightliner mt-45 step van. I'm looking for a cruise control for this rig. Rostra directed me to M&R Electronics. They said if it's a 6 wire, coming from the accelerator pedal they could possibly sell me one but it would be a diy job. I'm not too...
  9. 94-98 Non-Powertrain
    Hello Iam new to the fourm..... Back story for the damage that caused these issues most likely. On 12-21-20 I was stopped in trafic on the freeway, a three quater ton 300ft+ behind me was not slowing down I did not have anywere to go but take the hit.... So he hit me on the driver side his...
  10. 03-07 Non-Powertrain
    As long as my family has owned this truck for over 5 years, its cruise control never worked... the light turns on and off perfectly but it never engages. What are the possible problems that would cause this? There are zero lights on the dash and I dont know if this would throw a code.
  11. 03-07 Non-Powertrain
    I have been searching on this forum and all over the internet about my issue. My 2005 Dodge Ram 3500 4x4 Dually has an issue with the cruise control just coming on randomly. Mainly at lower speeds while driving through the city. Is it a clock spring issue or the ECU or some type of throttle...
  12. 2010-2012 Non-Powertrain
    My 2010's cruise control works all the time but the light on the dash is occasionally dim were you can barely see it and then sometimes its perfectly bright. I replaced the switch and that didn't seem to do anything. Any ideas?
1-12 of 12 Results
Top