Search Results for ‘airdog’

Hello all! I just ordered a new set of injectors along with a VP max under intake filter kit with 1/2 in line. Looking to replace/upgrade the lift pump next. Question being is there a good drop in replacement pump that doesn't require modification or should I be looking into kits that do require...

I recently started swapping my 02 cummins to a manual. Pump kicked on fine before starting the swap, midway into swap I decided to try and start the truck to make sure everything was fine before putting t-case in and finishing up and the airdog won’t kick on. I’m not good at all with wiring but...

I have a 1999 Ram 2500, 24v with a 70 Dodge cab on it. When driving a few days ago, the truck will not accelerate anywhere close to how it was performing before. I can get up to 3rd gear then I seem to reach a limit in how high the RPMs can climb. The truck now is unsafe to drive due to how...

I have a 2004 5.9 with a cts3 tuner,s&b cold air intake, 4 inch straight pipe and I’m looking to get a air dog 2 fast fuel pump. I want to get the 165gph but I’m worried of pressure and it just being to big for my truck. I’ve looked into the 100gph but I would like the higher gph. I know on the...

Hey everyone, brand new here to the site and looking for some input. I just inherited a 2000 2500 Cummins that had a bad injection pump. I’ve installed a new VP44 from Thoroughbred Diesel along with a AirDog II 4G 100GPH lift pump. I just have to finish tidying up the wiring harness then bleed...

Hey everyone, just wanted to post on here and share what I thought was an awesome warranty experience. Bought a Raptor 150 fuel pump back in 2014 from one of their dealers that has been great and given me no issues until about a week ago(7 years later). I called Pureflow and spoke with James...

Hello I have a 1998 Ram 3500 24v 5.9 cummins. I bought a airdog 2 4G 100gph lift pump. After installing the unit I put my key in the ignition to bleed the lines, upon doing so my dash now reads check engine and the truck does not crank. The code it is throwing it P1689. Please help because I...

Installing my Airdog II-4g 100g/hr pump today... got the fuel sender modified, pump on the rail under bed, and went to wire it up while the transfer pump was putting fuel back in the tank. Got the pump plugged in, positive and ground hooked up, and went to clip the last piece together... aka the...

2007 6.7 Cummins and we did a efi live tune on it and did a air dog raptor 150. We have a bad fuel leak and we can’t track it down we have looked all on the rail and fuel filter housing, CP3 pump is dry but filter housing soaked in fuel and so is the fuel rail. It drips off the bell housing and...

Truck has been sitting in the garage for about a week now because I have a leak between Fuel Rail Sensor Adapter and the Fuel Rail Sensor on an ATS twin fueler system. This issue causes a ton of fuel to spray out between the adapter and sensor. Got a new adapter to see if that would fix the...

What up fellas I got a 99 24v recently and the guy before me has this Oasis lift Pump on it. I’m looking to change the filters on it but I can’t find any information on the company/pump anywhere. The guys before me who had the truck for 30kish miles said he had never touched it, so it must’ve...

Im swapping a 24valve into a 82 ford f100 the thing is I bought the engine and tranny both for 1300 and is missing some stuff. It has no lift pump or filter on the block and was wondering if I could install a FASS or Air-dog and not have to put the factory lift pump and filter. Also would...

So I recently figured out that my air dog hasn’t even been plugged in for who knows how long. I’m running duel cp3s and they have been buzzing when I turn the key to let it warm up. Curious as to how bad it is for the cp3s to basically act as a lift pump?