Cummins Diesel Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-19 of 19 Results
  1. 2010-2012 General Discussion
    so i replaced my thermo on my 2011 6.7 and i also replaced the water pump i bought a rad for it its over heating and i can’t figure it out i’ve gotten what i think is all the air out of the system and i have heat here and there need to get my truck back on the road. i’m at a dead end i haven’t...
  2. 2013-2018 Powertrain
    So I had to replace my turbo actuator there for had to drain my coolant , after replacing the actuator I took it to jiffy lube to refill and flush my coolant , truck keeps saying it’s low on coolant but the resivor is topped off , I checked my 2” coolant line and it’s soft even after the truck...
  3. 2013-2018 General Discussion
    So I am installing a S300 2nd Gen swap from blessed performance and have everything install via turbo wise except the darn stock turbo drain line. The kit comes with an extension which was easy to install into the block but I am fighting install the stock tube into the extension itself. Any help...
  4. 2013-2018 Non-Powertrain
    Hey y’all. I’ve been fighting my truck 2013 ram 3500. Replaced all ball joints. Can’t keep the truck in a lane without running the center line. Wheel is hard to smoothly turn. I’m kinda thinking it’s the gearbox. I adjusted the gearbox little by little and problem only got worst any thoughts...
  5. 2013-2018 Powertrain
    I have a 2013 6.7 it’s a manual if that’s important. On my way to work the CEL came on didn’t have time to check it until after work. Drove to O’Reillys and the codes that came up were P0046 and U010C. The turbo still spools but I can only get about 10 pounds of boost and the exhaust break works...
  6. 2010-2012 Powertrain
    driving to work truck slammed into 3rd and stayed in third until i reset the truck. when fueling at gas station i turned the truck off for 10mins and was able to drive just fine for 15mins to work. besides the engine light on no issues. leaving work it happened again, 3 gear limp mode...
  7. 911 Urgent Situations Archive
    I am hoping someone here has some input. I have hit my mental capacity. I am really reaching for help here. Ive done a ton of work to the truck, and just can't figure out what went wrong. It's been down for 7 months now. And thousands of dollars have been spent. It's a long story , but here we...
  8. 2010-2012 Powertrain
    Bought a 2018 Ram from a buddies tow yard which he towed from a shady yard that had multiple stolen vehicles. On arrival I saw I wasn’t seeing a fuel level. Dropped the tank and saw the fuel pump was off and broken. Replaced low pressure pump and primed the truck then saw fuel squirting out CP3...
  9. 4th Gen Performance Parts Discussion
    So this weekend i got the head back in my truck. Been piecing it back together and noticed when I got to the push rods that the heighth of the headstud was almost level with the pushrod. Im guessing i didnt thread them down enough? Thought I had bottomed it out then went back half a turn who...
  10. 2013-2018 Powertrain
    With the awkward title wording out of the way, the real problem is I am in the process of putting a new turbo in my 2015 2500 and I put the oil and coolant return lines on the turbo first. The dealer can take a hike some $9500 to replace the turbo, which is why I’m doing it myself. The truck is...
  11. AlfaOBD
    I'm new to the forum, I tried looking for the correct place to ask this question and I hope this is the spot, if not delete if not allowed. So I purchased a 2016 Ram 2500 6.7, 68rfe, Megacab, 4x4, laramie. Upon purchase I knew it needed a turbo actuator replaced, so I bought alphaobd & an mx+...
  12. 2013-2018 Powertrain
    First time poster , long time reader. Hoping someone can help me here. I have a 2016 6.7 cummins. So far it's only deleted and tuned . It has 107 k miles on it. I did the tune and delete around 90k miles. The tunes are clean on every setting. Never smoked. A few months ago, before the weather...
  13. AlfaOBD
    I am getting efi live and I am going to get the obdlink mx+ and alfa obd programming any advice to procedures and stuff to avoid I'm looking to shut off the tire pressure system calibrate the tire size and keep my fogs on with high beam and I wanted add a second key possibly add the remote start...
  14. 2010-2012 Non-Powertrain
    I have made mention of switching out my mini maxx system it works great but with my mods I need custom tuning now. So now I need to do the alfa one to shut off tire light due to I don't have tire sensors and I wanna keep my dog lights on with high beam which the mini maxx did so I have a google...
  15. Remi

    Fully deleted, 50 horse ddp injectors, fleece cheetah turbo, fleece intank pump, hmm cat filter kit, fluidampr balancer
  16. 4th Gen Performance Parts Discussion
    I have a 2012 2500 I have the mini maxx tuner on it and I have other kids but it seems I do not have the power it should when I want it too and I been pawing around going custom tunes but noone offers them for mini maxx anymore. I wanna see your guys opinions on the products available who to get...
  17. 2010-2012 Powertrain
    Hey y'all, I just bought my first cummins. It's a 2012 4x4 2500 6.7 RAM with 202k. This truck has a mini maxx 2 with egt probe, hamilton 07-CC-24v178 towing camshaft combo, valve springs & lifters, APR head studs, Fass titanium signature series 165 GPH lift pump, full shibby delete with grid...
  18. 2013-2018 General Discussion
    Forum Newbie here! I've got an '18 6.7 with a 68rfe that I tow roughly a 10k 5er with at least once a month. Really happy with the Cummins power. Issue that I've noticed is on climbs. Big or small, short or long. It hits 4th gear and pretty much stays there. I can floor it and it just...
1-19 of 19 Results
Top