Dodge Cummins Diesel Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-20 of 36 Results
  1. Introductions
    Ok which one of you yo-yos is smart enough to tell me how to wire up a Diablo puck to a second gen Cummins. 2000 model to be more specific. And for you clowns at the part store..... it’s a 4wd. 3-2-1 GO!!
  2. 98.5-02 Powertrain
    I have a 1999 Ram 2500, 24v with a 70 Dodge cab on it. When driving a few days ago, the truck will not accelerate anywhere close to how it was performing before. I can get up to 3rd gear then I seem to reach a limit in how high the RPMs can climb. The truck now is unsafe to drive due to how...
  3. 98.5-02 Powertrain
    99 Cummins 24v. Automatic. 30k miles on Jasper transmission. (Out of warranty since it was replaced 4 years ago) The issue I'm having is.. it will not shift into 3rd gear with overdrive on but, with overdrive off it will shift into 3rd gear. What would cause this issue? Thank you!
  4. 98.5-02 Performance Parts Discussion
    Anyone know some good higher hp injectors for stock fuel and air system? my injectors have 290k miles on them and i’m gonna replace them with bigger ones but not trying to go huge but would like a little smoke and power. Any recommendations?
  5. 98.5-02 Performance Parts Discussion
    2002 24v Cummins, arp head studs firepunk comp1 with stock stall converter, 3.55 gears, 250hp injectors, hot rod vp44, fass 150, quadzilla tuner Was looking into compounds as the turbo I have now does it’s job but I want more power and 100% need lower egt as cruising at 65 egt is 900 and will...
  6. 98.5-02 Non-Powertrain
    Hey all, iv got a 01 24v, previous owner had the map unplugged. After a little research iv seen that some folks say it can improve low-end power. It also rolls a decent amount of coal when you really get on it. i could care less about smoke, however is there any real gain to having the MAP...
  7. 98.5-02 Performance Parts Discussion
    OK so recently I got my hands on A HX40 to build a hybrid out of my 35. 1st thing I did was separate the HX40 down to basically the turbine shaft with a compressor wheel Off. Once that was complete I went to cleaning the Turbo as best as I could and and had a spare HX35 cartridge laying around...
  8. 98.5-02 Powertrain
    Thank y'all for many years of help and info especially y'all big contributors. My 02 has been having dead pedal at start, while hauling at less than 2k rpm and other occasions. At first sign 8 months ago I received the P0216 code. I changed to an in tank lift pump, Delphi or whatever it was the...
  9. 98.5-02 Powertrain
    Hey guys, I have a 2002 Dodge Ram Cummins, 6 speed. My truck has been acting up. When I'm driving, the truck is cutting out on me from time to time, leading it to actually cutting out completely and dying. The truck starts right back up every time. Almost seems like a short of some sort? Maybe a...
  10. 911 Urgent Situations
    Hello all, I’m in a huge time crunch at the moment and could really use help, A bit of my background, I’ve owned at 93 and 95 12V, a 08, 09 and 10 6.7 and now own a 98.5 24V. the current truck 98.5 24V ran out of fuel one day and I’m assuming killed the fuel pump and VP44, I replaced the fuel...
  11. 98.5-02 Powertrain
    Hi, I have a 98 24v and when the truck is warm and I get on it (probably 2300-2500 rpm) quickly, I get a loud squeal once boost builds high enough. It sounds like it is coming from the drivers side. I think there is a vacuum pump by he driver side battery? Has anyone dealt with this before? It...
  12. 3rd Gen. Powertrain
    Spun a bearing looking to rebuild, crank may be trashed beyond reasonable repair. Been searching and found a shaft with no gears says it will work 89-07, given the correct gear installed for generation, straight or helical, with that being said can a take a 99-02 24vcrank and use it just replace...
  13. 98.5-02 Powertrain
    I recently picked up a 1999 2500 5.9 Cummins that came with no front drive shaft. With ease I can spin the front pinion. Im new to 2nd gens and was wondering if someone cloud clarify if this is normal or if there is a bigger issue at hand.
  14. 98.5-02 Performance Parts Discussion
    If I take off the rockers to put on head studs and maybe valve springs do I have to reset the valve lash or will it not move. Also, what are the advantages of doing aftermarket push rods? I’m gonna build the hp on my truck slowly and I’m wondering if they are necessary.
  15. 98.5-02 Performance Parts Discussion
    I’m gonna put head studs on it soon. But I’m just wondering if I have any change of floating a valve. I’m pushing 45 pounds of boost max.
  16. 98.5-02 Powertrain
    2002 2500 5.9 24V Cummins auto trans 375k miles bone stock Truck was running great no issues one day was driving went about 20 miles and the truck completely died. Couldn’t get it to turn over, gave it a tiny shot of ether and it turned over. Ran about another 10 miles and it died again...
  17. 98.5-02 Performance Parts Discussion
    Hello Everyone, new to the form. I'm trying to size the right injectors for my truck. Its a 01 24v, with compounds on it (62/71/.07 over a S480). I did head studs, o-ringed the head, and high rev valve springs when I put the compounds on it. I'm running a ZF6 and 3.73s. Right now I'm running...
  18. 98.5-02 Powertrain
    I recently was driving my truck when I noticed the truck was revving a lot higher before shifting and slipping very bad, it then got very worse and I noticed a bad ATF leak. I found the leak, it was a transmission cooler line that had a hole rubbed into it. I had the line replaced and refilled...
  19. 3rd Gen. Powertrain
    Recently did an overhaul on my 5.9 Cummins. Everything went smoothly and had no problems assembling. Before dropping the pistons in I checked each ring gap and everything was perfectly in spec. Only put brand new parts into the engine... nothing was reused. Truck started right up on its first...
  20. 98.5-02 Powertrain
    I have recently purchased my first diesel it’s a 99 qcsb ppumped swap with a nv4500 swap done years ago by a diesel shop in pa. From what I’ve read on the receipts it has a Southbend DD. I could give further info on full build later if that helps me pinpoint my concern. Now to the point when I...
1-20 of 36 Results
Top