Dodge Cummins Diesel Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-8 of 8 Results
  1. 4th Gen Performance Parts Discussion
    Hello all, I have a 2010 6.7. I've done nothing to the rig myself... 🤔😉 I recently checked my codes and the only one that comes up is P144e. I can clear it but it immediately returns. My question is this; since it's a matter of the Bypass status being seen by the computer as 'low' can the pin...
  2. 2010-2012 Non-Powertrain
    Recently my PS steering pump went on the 2010 2500, I got a replacement and did everything - the job went really smoothly up until the bleeding process... I tried what feels like every imaginable method to try and bleed the air completely out. Although I got very close - there is still some air...
  3. 2010-2012 General Discussion
    Hey guys just got this truck and it's a crew cab with a short bed. I took it yesterday to put a gooseneck (B&W hideaway) in at a local shop, and it measures 2' 6 1/2" from the back of the bed (inside the bed) to the center of the ball for the gooseneck. I already bought the 4" offset, but I...
  4. 2010-2012 Non-Powertrain
    My 2010's cruise control works all the time but the light on the dash is occasionally dim were you can barely see it and then sometimes its perfectly bright. I replaced the switch and that didn't seem to do anything. Any ideas?
  5. 2010-2012 General Discussion
    So I've previously owned several 5.9L dodges but just jumped into my first 6.7L yesterday. A beautiful 2010 2500 CC LB 4x4 Laramie. So far, I've run into two issues. I was told it used DEF but there's no fill port next to the fuel fill port... I just found out earlier today that i have no heater...
  6. 2010-2012 General Discussion
    I have a Deleted 2010 6.7 Cummins and its pretty much stock minus a 5 position tune (Stock-towing (8k-)-towing (8k+)-sport-Race), exhaust, cold air intake and Banks intercooler pipes. My CTS3 monitor is reading 35-37 KPSI fuel rail pressure at idle and that doesn't seem possible. The truck runs...
  7. 2010-2012 General Discussion
    Hi! I’m sure the answer is on here somewhere but I am tired of looking... I recently purchased a EGR delete kit for my 2010 3500 Cummins. I am wondering if installing this will require a tuner. I’ve seen multiple post stating one or the other. Any help would be great! Thanks!
  8. 3500

    chillin in the drive
1-8 of 8 Results
Top