Dodge Cummins Diesel Forum - Reply to Topic
2013-2018 General Discussion General Chit Chat About the 2013 model year differences 6.7L 4th generation Cummins - NO ADVERTISING - Sponsored by: StarLite Diesel

Thread: NOX Sensor Issue Reply to Thread
Title:
Message:
Trackback:
Send Trackbacks to (Separate multiple URLs with spaces) :
Post Icons
You may choose an icon for your message from the following list:
 

Register Now



In order to be able to post messages on the Dodge Cummins Diesel Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.

User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.

Password:


Confirm Password:
Email Address
Please enter a valid email address for yourself.

Email Address:
OR

Log-in










  Additional Options
Miscellaneous Options

  Topic Review (Newest First)
10-21-2019 10:43 AM
Coyote914 Pull the Right front Tire and inner Fenderwell off. Take the Heat Shield off that protects the Sensor (8mm) then use a 22 mm wrench to remove sensor. A 22 mm is a little bit too big in a 21 mm will not fit, I also could not get any standard wrench to fit properly either. I took a little black tape and wrap around one side of my 22 mm open end to take up the slack. May even have to put a small cheater pipe on the other end of the wrench because itís in their tight.
10-21-2019 08:51 AM
99ls1tj What did you use to get the sensor out? I need to change that one. Thx
10-20-2019 10:12 AM
Coyote914 I changed the NOX/O2 Sensor right down from the Turbo. It’s located in the Elbow coming off the Turbo. I also checked the plug on the Harness. I have one wire hot+ and the other 3 are -ground without the sensor being plugged in to the Harness.
10-19-2019 11:44 PM
Ltngdrvr It's a fault in the O2 sensor heater circuit.

Could be in the sensor, could be in the harness, either a ground fault or hot wire short.
10-19-2019 07:08 PM
Jimmy07
Quote:
Originally Posted by Coyote914 View Post
Ok, cool. I have a code P0030 and after looking it up I ordered a new NOx temp sensor number one position and replaced it. Iíve cleared the codes with two different devices but the code remains and now it has my truck in limp mode 5 mph. Any suggestions.
Thatís an O2 sensor 1/1 fault. Exactly what sensor did you replace? NOX, temp, or O2, and which one (from closest to furthest from engine)?
10-19-2019 06:18 PM
Coyote914 Ok, cool. I have a code P0030 and after looking it up I ordered a new NOx temp sensor number one position and replaced it. Iíve cleared the codes with two different devices but the code remains and now it has my truck in limp mode 5 mph. Any suggestions.
10-19-2019 04:13 PM
chknkatsu
Quote:
Originally Posted by Coyote914 View Post
Hey guys can someone direct me to the proper area to ask questions about my NOX sensor please.
you can ask right here
10-19-2019 03:00 PM
Coyote914
NOX Sensor Issue

Hey guys can someone direct me to the proper area to ask questions about my NOX sensor please.

Posting Rules  
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

 
For the best viewing experience please update your browser to Google Chrome