Dodge Cummins Diesel Forum

Dodge Cummins Diesel Forum (https://www.cumminsforum.com/forum/)
-   2013-2018 General Discussion (https://www.cumminsforum.com/forum/2013-2018-general-discussion/)
-   -   NOX Sensor Issue (https://www.cumminsforum.com/forum/2013-2018-general-discussion/2513961-nox-sensor-issue.html)

Coyote914 10-19-2019 03:00 PM

NOX Sensor Issue
 
Hey guys can someone direct me to the proper area to ask questions about my NOX sensor please.

chknkatsu 10-19-2019 04:13 PM

Quote:

Originally Posted by Coyote914 (Post 29118957)
Hey guys can someone direct me to the proper area to ask questions about my NOX sensor please.

you can ask right here

Coyote914 10-19-2019 06:18 PM

Ok, cool. I have a code P0030 and after looking it up I ordered a new NOx temp sensor number one position and replaced it. Iíve cleared the codes with two different devices but the code remains and now it has my truck in limp mode 5 mph. Any suggestions.

Jimmy07 10-19-2019 07:08 PM

Quote:

Originally Posted by Coyote914 (Post 29119075)
Ok, cool. I have a code P0030 and after looking it up I ordered a new NOx temp sensor number one position and replaced it. Iíve cleared the codes with two different devices but the code remains and now it has my truck in limp mode 5 mph. Any suggestions.

Thatís an O2 sensor 1/1 fault. Exactly what sensor did you replace? NOX, temp, or O2, and which one (from closest to furthest from engine)?

Ltngdrvr 10-19-2019 11:44 PM

It's a fault in the O2 sensor heater circuit.

Could be in the sensor, could be in the harness, either a ground fault or hot wire short.

Coyote914 10-20-2019 10:12 AM

I changed the NOX/O2 Sensor right down from the Turbo. It’s located in the Elbow coming off the Turbo. I also checked the plug on the Harness. I have one wire hot+ and the other 3 are -ground without the sensor being plugged in to the Harness.

99ls1tj 10-21-2019 08:51 AM

What did you use to get the sensor out? I need to change that one. Thx

Coyote914 10-21-2019 10:43 AM

Pull the Right front Tire and inner Fenderwell off. Take the Heat Shield off that protects the Sensor (8mm) then use a 22 mm wrench to remove sensor. A 22 mm is a little bit too big in a 21 mm will not fit, I also could not get any standard wrench to fit properly either. I took a little black tape and wrap around one side of my 22 mm open end to take up the slack. May even have to put a small cheater pipe on the other end of the wrench because itís in their tight.


All times are GMT -4. The time now is 10:32 AM.

Powered by vBulletin® Copyright ©2000 - 2019, vBulletin Solutions, Inc.
User Alert System provided by Advanced User Tagging (Pro) - vBulletin Mods & Addons Copyright © 2019 DragonByte Technologies Ltd.
vBulletin Security provided by vBSecurity v2.2.2 (Pro) - vBulletin Mods & Addons Copyright © 2019 DragonByte Technologies Ltd.

 
For the best viewing experience please update your browser to Google Chrome