Perform Service message reset, Seat Belt Chime disable - Dodge Cummins Diesel Forum
2013-2018 General Discussion General Chit Chat About the 2013 model year differences 6.7L 4th generation Cummins - NO ADVERTISING - Sponsored by: StarLite Diesel

 13Likes
  • 13 Post By Ltngdrvr
 
LinkBack Thread Tools Display Modes
post #1 of 9 (permalink) Old 01-29-2017, 06:39 PM Thread Starter
Diesel Head
 
Ltngdrvr's Avatar
 
Join Date: Jul 2014
Location: Southeast TX
Posts: 12,630
Thanks: 18
Thanked 2,180 Times in 1,622 Posts
iTrader Score: 0 reviews
Perform Service message reset, Seat Belt Chime disable

Been needing to reset the Perform Service message for about 10 days, finally went out and did it. Had replaced the CCV filter a few weeks ago, at that time the message hadn't come up yet.

At the same time I disabled the seat belt chime, as there are many times when hooking and unhooking a trailer or driving around the yard searching for a trailer, having to hop in and out of the truck, when it gets annoying. You still get the EVIC message and the light, but no incessant dinging.

Anyway, thought I'd repost the procedures for both of these chores for anyone who needs them.

PERFORM SERVICE INDICATOR - RESET
Unless reset the “Perform Service” message will display on the EVIC each time you turn the ignition switch to the ON/RUN position to indicate a emission maintenance is required. To reset the “Perform Service” indicator system (after performing the scheduled maintenance) refer to the following procedure:
1. Turn the ignition switch to the ON position (Do not start engine).
2. Press and release the brake pedal two times.
3. Fully depress the accelerator pedal slowly two times within 10 seconds.
4. Turn the ignition switch to the OFF/LOCK position.
NOTE: If the indicator message illumination when you start the vehicle, the “Perform Service” indicator did not reset. If necessary repeat this procedure.




Seat Belt Chime Disable
1. With all doors closed and the ignition switch in any
position except On or Start, buckle the driver’s seat belt.
2. Turn the ignition switch to the ON position and wait
for the Seat Belt Warning Light to turn off.
3. Within 60 seconds of turning the ignition switch to the
ON position, unbuckle and then re-buckle the driver’s
seat belt at least three times within 10 seconds, ending
with the seat belt buckled.
NOTE: Watch for the Seat Belt Warning Light to turn on
while unbuckling and off while re-buckling the seat belt.
It may be necessary to retract the seat belt.
4. Turn the ignition switch to the LOCK position. A
single chime will sound to signify that you have successfully
completed the programming.
The Enhanced Warning System (BeltAlert) can be reactivated
by repeating this procedure.


2015 RAM 2500 LoneStar Mega Cab CTD 2WD Air Ride PRAIRIE PEARLCOAT 02/09/2015
CCV reset/seatbelt chime disable https://www.cumminsforum.com/forum/2...tml?highlight=
Ltngdrvr is online now  
The Following 18 Users Say Thank You to Ltngdrvr For This Useful Post:
5001craig (10-10-2018), ArizonaRick (11-28-2018), CowboyCummins01 (04-10-2019), CTD&TDI (11-19-2017), dfeland (01-31-2017), dgiturbo (07-22-2017), diesel35 (07-21-2017), Fanman43 (02-01-2018), felix (01-29-2017), Fink117 (01-30-2018), Josephc1 (03-27-2018), just one more (02-09-2017), nick00less (07-20-2017), SeventyGTX (09-14-2018), str8t six (01-29-2017), The Hulk (01-29-2017), Thumper2016 (01-30-2017), ylwiron (03-03-2019)
Sponsored Links
Advertisement
 
post #2 of 9 (permalink) Old 01-29-2017, 08:44 PM
KAG
Cummins Fan
 
KAG's Avatar
 
Join Date: Nov 2016
Location: Kansas
Posts: 53
Thanks: 1
Thanked 10 Times in 7 Posts
iTrader Score: 0 reviews
Very cool, will try the chime disable in the morning

2016 2500 Diesel 4WD Tradesman /2018 3500 Diesel 4WD Tradesman *Aisin* w/11.8 rear / 2001.5 3500 Diesel 4WD (After 18 yrs sold)/ Bobcat863 Deutz Diesel Deutz 40hp Turbo Diesel 4x4 Tractor/ 1140 Arctic Fox TC
KAG is offline  
post #3 of 9 (permalink) Old 01-30-2017, 09:16 AM
Diesel Freak
 
azjohnnyo's Avatar
 
Join Date: Jul 2015
Location: Mesa, AZ
Posts: 607
Thanks: 168
Thanked 100 Times in 81 Posts
iTrader Score: 0 reviews
So Far that has worked in every FCA vehicle I have been in...about 5 rental vehicles, my truck and my wife's Jeep GC!!

2015 2500 4X4 CC Laramie in Black Forest Green 6.7 w/68RFE. N-Fab step bars, BakFlip HD Tonneau cover.
"What if the HOKEY POKEY "IS" what it's all about?"
"An honest government has no fear of an armed population".
azjohnnyo is offline  
Sponsored Links
Advertisement
 
post #4 of 9 (permalink) Old 01-30-2017, 09:19 AM
Diesel Head
 
Ratdog1's Avatar
 
Join Date: Dec 2011
Location: Billings Mt.
Posts: 5,145
Thanks: 2,395
Thanked 4,036 Times in 3,010 Posts
iTrader Score: 0 reviews
Subscribe 8 9 10....
For future use. ..
Sent from my SAMSUNG-SM-T217A using Tapatalk

2016 4x4 3500 Laramie CCLB LOST MY EXHAUST SO I HAVE AN 18 INCH RESONATOR AND EGRDELETE.. ALSO HAVE EFILIVE BY PPEI 3.42 rear ,68 trans TUNED BY PPEI
Ratdog1 is offline  
post #5 of 9 (permalink) Old 07-20-2017, 06:21 PM
Diesel Freak
 
DODGE4X4's Avatar
 
Join Date: Nov 2006
Location: South Texas
Posts: 611
Thanks: 230
Thanked 91 Times in 60 Posts
iTrader Score: 0 reviews
I've been getting this message every time I haul a trailer. Fuel, oil & air are good but I forgot about the CCV. I'm sitting at 47,000 miles I guess it could be bad. What else could this message be for?

2016, Cummis, 2500, LongHorn, 4x4- AMP Steps, Ranch Hand bumpers, 285/75R18 Toyo MT
2016, Laramie Power Wagon - AMP Steps, Fab Fours bumpers, 285/75r17 Toyo MT's (Wife's)
2016, Challenger SRT Hellcat, M6 (Garage Queen Toy)
DODGE4X4 is offline  
post #6 of 9 (permalink) Old 07-20-2017, 08:50 PM
Diesel Head
 
Jared Herzog's Avatar
 
Join Date: Sep 2009
Posts: 2,716
Thanks: 354
Thanked 341 Times in 288 Posts
iTrader Score: 0 reviews
Perform Service message reset, Seat Belt Chime disable

Quote:
Originally Posted by DODGE4X4 View Post
I've been getting this message every time I haul a trailer. Fuel, oil & air are good but I forgot about the CCV. I'm sitting at 47,000 miles I guess it could be bad. What else could this message be for?


Could the cardboard duct feeding the filter box in the fender be collapsed? Then the trucks sees a restriction and thinks it is the air filter. If it happens towing it is because the truck needs more air and is not getting it. I have seen it on some 13 and 14 trucks. The hose is said to be better on the newer trucks. I have not had this issue with my 15 yet. Or your ccv filter may be full. Good luck

Thanks for the info on the seat belt. I am tired of driving around customer ranches with the non stop ding ding ding ding.

Ram 14 2500 RIP 14,700 Stock. 68RFE."The Lemon"
Ram 15 3500 Dually. Stock. Aisin. N Fab wheel to wheel. Weather Tech Mats. Big D Steering Box Brace.
Jared Herzog is offline  
The Following User Says Thank You to Jared Herzog For This Useful Post:
DODGE4X4 (07-20-2017)
post #7 of 9 (permalink) Old 07-21-2017, 11:56 AM
Cummins Fanatic
 
Striper05's Avatar
 
Join Date: Jan 2017
Posts: 193
Thanks: 9
Thanked 11 Times in 10 Posts
iTrader Score: 0 reviews
Nice informative report. Thanks


Sent from my iPad using Tapatalk
2016 3500CC 4X4 6.4 bed CTD
Striper05 is online now  
post #8 of 9 (permalink) Old 07-21-2017, 05:44 PM
Diesel Freak
 
Flash1034's Avatar
 
Join Date: Dec 2014
Location: Southern California
Posts: 563
Thanks: 28
Thanked 37 Times in 36 Posts
Garage
iTrader Score: 0 reviews
Great post. Thanks for taking the time.

2017 Ram 3500 MegaCab 4x4 Laramie, SRW, Cummins/Aisin, Sport Appearance Group, Dual Alternators, NAV, loaded except for rear air suspension.
Flash1034 is offline  
post #9 of 9 (permalink) Old 07-21-2017, 08:50 PM
Cummins Nut
 
bgchuby01's Avatar
 
Join Date: Jan 2009
Location: Rancho Cucamonga, Calif
Posts: 351
Thanks: 33
Thanked 42 Times in 22 Posts
iTrader Score: 0 reviews
I have had my seatbelt disabled since new, I hate the seat belt. But thank you for the perform service delete

2016 3500 DRW 4x4 CC limited air suspension aisin 4:10 Pearl White
2004 2500 2wd 5.9 418,000 miles all original engine 22mpg
2017 2500 2wd 6.7 w/Rambox
bgchuby01 is offline  
Sponsored Links
Advertisement
 
Closed Thread

Quick Reply
Message:
Options

Register Now



In order to be able to post messages on the Dodge Cummins Diesel Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.

User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.

Password:


Confirm Password:
Email Address
Please enter a valid email address for yourself.

Email Address:
OR

Log-in










Thread Tools
Show Printable Version Show Printable Version
Email this Page Email this Page
Display Modes
Linear Mode Linear Mode



Posting Rules  
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On

 
For the best viewing experience please update your browser to Google Chrome