Cummins Diesel Forum banner
C

Reaction score
2

Marketplace Rating
(0.0 - 0 reviews)

Profile posts Discussions Buy & Sell Reviews Media Albums About

  • · Registered
    Joined
    ·
    3 Posts
    Was wondering if you could help. I have a 09 dodge ram 2500 megacab. I recently put a 6 inch fabtech lift in my truck. I had a 2 inch level kit that I left in when I put the new lift kit. I drove the truck for a day until I could get it re aligned. I had no problems, the shop told me I needed new ball joints so I replaced them. Had the truck aligned and now I have the death wobble really bad at 60 mph. I took it back to the shop and they say nothing is wrong with it. They tightened my pitman arm nut down and not the steering wheel shakes constantly at 55 mph. I took it to another shop and they are telling me that I need bigger steering stabilizers. I have dual rough country n2.0 stabilizers. Any help is appreciated as this is my daily driver and now have no vehicle to get to work.

    · Registered
    Joined
    ·
    60 Posts
    Hey any chance i could see a pic of your truck with the hood scoop. I read the post from a while back but cant find a pic. I want to put one on to try and get some more air

    · Registered
    Joined
    ·
    0 Posts
    im half way threw a transmissin swap on my 94 cummins and the only problem i have run into is all the sensors dont match up, the old transmission had a 3 pin sensor where there is now a seven pin and i have an extra sensor with nothing to plug it to it any suggestions?

    · Registered
    Joined
    ·
    10 Posts
    Looking for some answers,i have arrived in columbia sc from wis and plan to go back as soon as i can fix the 24 valve, i experenced a clatter in the engine after a hard long pull in one of the mountains,my guess is a lifter faikure or pushrod,missing a cylinder and no blowby or white smoke,just a loud clatter and a miss. iplan to remove the cover and see if there is any noticable issues but i need someone down here that has a shop etc. thanks

    · Registered
    Joined
    ·
    0 Posts
    Hey, I seen you are one of the "go to" guys and was hoping maybe you could help me out. I have a post in the 911 section. I have ran into another problem with my truck, I have replaced enough parts that I should have a new truck by now. My truck stranded me, I checked the codes and got P0628. Ignorantly I just ran out and got a new lift pump (in tank model). I popped it in and still nothing, so I checked voltage today and I'm not getting anything. Could you tell me what I need to look at next and where??? Thank you, Dusty

    · Registered
    Joined
    ·
    30 Posts
    Hey,
    Wondering if you could help without having to got o the dealer. I got a leveling kit installed about a month ago. About a week ago I noticed a poping noise comming from the driver side front end when I turn. I have been busy at work and havnt had a chance to get it looked at. Since Ive noticed it its getting louder. Any ideas? Thanks, Johnny

    · Registered
    Joined
    ·
    543 Posts
    hi, my name is jay(aka deezall) i have a post in 911 help section and i cant find the answer. ive searched and searched but to no avail. basicly i was wondering if you could help. im kinda new to the dodge (owning one anyway) i worked at a dealer for ten years as a tech but they closed after i left 5 years ago. so cant look at the books and fsm's anymore. any help you can give would be great. check out the post in the 911 section under dash lights dont work.
  • Loading…
  • Loading…
  • Loading…
  • Loading…
  • Loading…
  • Loading…
Top