👋 Welcome to the Cummins Diesel Forum
2019+ 4.5 Gen Ram 6.7 Cummins
2019+ “5th” Gen
2013-2018 4th Gen Ram 6.7L Cummins
Late 4th Gen Trucks- All with DEF
2010-2012 4th Gen Ram 6.7L Cummins
Early 4th Gen Trucks- Non DEF Pickups
2007.5-2009 3rd Gen Dodge 6.7L Cummins
DPF Equipped 6.7s
2003-2007.0 3rd Gen Dodge 5.9L Cummins
The High Pressure Common Rail 5.9s
1998.5-2002 2nd Gen Dodge 5.9L 24V Cummins
The VP44 5.9s
1994-1998.0 2nd Gen Dodge 5.9L 12V Cummins
The P7100 5.9s
1989-1993 1st Gen Dodge 5.9L 12V Cummins
VE pump 5.9s
Other Non-Dodge/Ram Cummins Applications
If your Cummins is in an HD truck, RV, Boat, etc, then this is your section!
Conversions - ShopTalk - Tools&Boxes - Fabrication
NO ADVERTISING
Discussion of the Cummins Conversions and Fabrication Needed to Complete. Talk about and show off your Tools - Tool Boxes & Shops. Show off your General Fabrication Projects
General Forums
Specialty Forums
Technical Articles - Writeups - Guides Section
Forum Resources
Marketplace
Member for at least 10 days with a minimum of 20 posts required to access
Vendor Member Section
Want to Grow Your Business? Learn more about becoming a Supporting or Premium Vendor
Regional Forums
Forum Support
Community Hall
Latest Posts
-
Good morning everyone! I have a 1998 12 valve with a 47RE transmission. I’m looking to do a G56 swap but have been struggling to find what I need to do with the wiring to bypass the neutral safety switch to start the tuck. If possible I would like to eliminate any check engine lights and would...3 replies 124 views
-
2019 Ram 6.7 , deleted and running great last week, took off from light traction control light came on than shortly went off than service Electronic Throttle control light came on and has been on for over a week not affecting truck it runs great I plan on taking to shop is it any thing to worry...1 reply 350 views
-
In the morning when it's cold or wet out the wiper intermittent positions don't work at first but eventually start working once the truck warms up. The module plastic near the connector shows signs of melting but I think the module is working properly and maybe the connector pins are not making...4 replies 156 views
-
Thought I asked this, but maybe not here... Having a converter done tomorrow (local shop, cut, rebuild, upgrade). I have the option to go low stall (1600ish rpm) for added $. For a basically stock engine with a few free power mods, and the 727 (which is going to be redone also), does 1600 rpm...2 replies 84 views