đź‘‹ Welcome to the Cummins Diesel Forum
2019+ 4.5 Gen Ram 6.7 Cummins
2019+ “5th” Gen
2013-2018 4th Gen Ram 6.7L Cummins
Late 4th Gen Trucks- All with DEF
2010-2012 4th Gen Ram 6.7L Cummins
Early 4th Gen Trucks- Non DEF Pickups
2007.5-2009 3rd Gen Dodge 6.7L Cummins
DPF Equipped 6.7s
2003-2007.0 3rd Gen Dodge 5.9L Cummins
The High Pressure Common Rail 5.9s
1998.5-2002 2nd Gen Dodge 5.9L 24V Cummins
The VP44 5.9s
1994-1998.0 2nd Gen Dodge 5.9L 12V Cummins
The P7100 5.9s
1989-1993 1st Gen Dodge 5.9L 12V Cummins
VE pump 5.9s
Other Non-Dodge/Ram Cummins Applications
If your Cummins is in an HD truck, RV, Boat, etc, then this is your section!
Conversions - ShopTalk - Tools&Boxes - Fabrication
NO ADVERTISING
Discussion of the Cummins Conversions and Fabrication Needed to Complete. Talk about and show off your Tools - Tool Boxes & Shops. Show off your General Fabrication Projects
General Forums
Specialty Forums
Technical Articles - Writeups - Guides Section
Forum Resources
Marketplace
Member for at least 10 days with a minimum of 20 posts required to access
Vendor Member Section
Want to Grow Your Business? Learn more about becoming a Supporting or Premium Vendor
Regional Forums
Forum Support
Community Hall
Latest Posts
-
Trying to fine-tune my alignment now that I’m on my new tires, stock 265/70/17. it feels like it kind of wanders at high speeds. I’ve got some angle iron I’m gonna make brackets to do good measurements, I’ll take the front wheels off and bolt the brackets to the hubs. Should I do zero, dead...6 replies 137 views
-
My truck was a factory Auto swapped to 5 speed trans. So I have found some auto trans remnants, but I don't know if this is one or what it is? Anyone know? 1 pic shows where hoses connect to the other shows the ends that were cut off.0 replies 21 views
-
I'm going to start this thread again and hopefully it won't go off the rails and get closed. Installed new hubs. Amazing, the truck tracks straight down the road now and doesn't have an annoying click in the steering wheel anymore. Also installed the replacement drag link tie rod since I...8K replies 727K views
-
Thought I asked this, but maybe not here... Having a converter done tomorrow (local shop, cut, rebuild, upgrade). I have the option to go low stall (1600ish rpm) for added $. For a basically stock engine with a few free power mods, and the 727 (which is going to be redone also), does 1600 rpm...0 replies 9 views