|
|
: 94-98 Powertrain
- about headgaskets...
- tranny going out or what??HELP!!
- Cold Coolant temp
- raptor 150 retrofit
- Rusted fuel lines
- Need help with making less smoke (stock) to pass emissions.
- torque converter stuck?
- Valve help! Urgent!
- big big big tranny issue.
- Money else where
- 97 dodge broke
- Throttle Cable Help
- tranny shifting problem
- highway rpms?
- Tps or apps
- how do i visually tell the difference between dana 60 and 70 rear axles
- Engine Racing on start up after rebuild
- trouble starting
- beefing up a auto tranny
- lock outs
- need help with a 95, i want to turn up the fuel
- Need an opinion that I probably know the answer too
- automatic transmissions
- what fully billet auto trans is everybody running
- injector difference
- getting another 12v need some answers
- Transmission Fittings size running lines help.
- 95 auto, 120k miles, looking for transmission advice(plowing)
- TC lock up fixed, I hope!
- Where to begin?
- earl
- 3500HD 2wd conv. to 4wd question
- low temp?
- KDP Questions
- Transfer Case Noise
- 96 rear axle seal?
- no tach or speedometer or overdrive
- rear axle issues
- Idle Adjustment
- Struts/shocks etc...
- Fuel plate
- Time for a turbo
- Injection lines issues, need advice.
- What just happened?!
- Cheapest place to buy a camshaft?
- part numbers
- Transmission (47RE) need expert help poor shift
- Dual Disk Clutch Install
- need some help
- 97RE Help
- auto t case in a 5 speed
- 46RH and 47RH use the same case?
- Clutch or Slave?
- CTD as a Log Skidder & How do you Lower EGTs for Hauling?
- wicked bad oil leak
- Increasing mileage with my 12 valve.
- ats trans controller
- Tranny help
- front and rear diff fluid suggestions?
- tranny issue
- Maxing out the gauge
- 47rh valve body remove
- ??? Clutch ????
- Bad MPG's
- HX35 oil supply fitting size.... Need help ASAP
- No 4WD
- 94 2500 2wd lower ball joints ? Not replaceable??
- 95 47rh no lockup
- Loud clunk when put it in gear.
- no muffler
- front u joints
- New truck
- Tabbed the KDP, quick question!
- What to do if truck will be sitting for 2-3 months?
- Stuck plunger?
- 12 valve oil pressure?
- turbo guys help!!!!!!!!
- High pitched whining sound at heavy throttle
- How Much Coolant Can This Truck Drink?
- trans help questions
- help with new truck
- Timing tools
- Please help
- how to get beyond 45mph
- engine build and ford swap
- How Much Coolant Can This Truck Drink?
- Starter Lesson
- Torque Converter shutter help
- wastegate frozen
- Leaky Transfer Case
- Ecm 54 +55
- Got lucky KDP missing
- Vibration in the rear end.
- '95 cummins rough idle
- blown head gasket????
- truck shutting off when driving
- Miss until 1750 rpms?
- 12V Fuel Plate
- '97 4x4 front end rebuild
- p7100 fuel sol
- bad fan clutch??
- trans help needed
- nv4500 slave same as nv5600?
- cummins 6 speed conversion
- transmission or t case
- Valair clutch on my lightly built pickup
- taking apart a 3 piece manifold
- Rough running just off idle..
- No pre boost adjustment?
- Front output shaft on transfercase movement?
- FASS and Airdogs
- Famous death wobble
- Transmission shifting in and out of OD erratically.
- Towing with my '94 Dually
- ARP Head Studs
- Please help asap!!!!
- Broke cam or tappets
- Lost oil cap on a 96 CTD
- BD - 2 low unloc kit
- Buying a cummins
- Transsmisson rebuilt
- transplant of 12v in 99 2500 4x4
- Bought a 1997 quadcab 12v 5spd
- Shut down sol ?
- trouble starting
- My 1st hard start...Help?
- Please help!
- np241 input shaft?
- Fuel Plate
- fresh rebuild, now won't crank over
- Fifth Gear Lock Nut Retainer
- 96 47re no OD or lockup
- Front End Pulling To Right
- AFC tuning starting points??
- new started batteries headgasket and wont turn over?
- dead battery now don't have speedo and starts in 2nd or 3rd?
- Which Hub assembly?
- help with 12 valve swap in a 99 24valve truck
- Stretching overflow valve spring
- Real hard starting, fuel leak present in behind primer.
- extremely low power! please help!
- Bendix Compressor Gear
- Tranny swap
- Is it bad to have to give the truck gas when starting?
- Trans Temp Light on
- 95 vs 98 fuel tank module
- Oil pan gasket
- Freeze Plug Change Question
- Cleaning out sludge and deposits with kerosene?
- engine start-up out of the truck
- Removing AFC Housing
- cylinder head break in
- tranny help
- Got in accident need some advice
- 6th cylinder heating up
- newb havingt/c unlock woes?????
- anyone in california. wanna swap trans?
- Took my Turbo Silencer ring off
- r u serious....?
- Fuel heater delete. Now won't crank..
- Anyone here running a TransGo shift kit?
- Surges/dies when warm
- turbo rebuild
- NV4500 problems
- Fleetguard oil filters
- Got in an accident doing a frame swap have some questions
- is tc slipping or trans downshifting???
- sometimes unconsistant idle and stalling at stop
- Cnt' figure this one out
- 47rh wont kickdown even with tv cable maxed and TQ possibly bad?
- what am i missing
- 96 Dodge Ram 2500 "Oil Blow By"
- Cummins Master NEEDED!
- fan pulley bearing....
- 12v fuel gauge sending unit from a 2001
- 4x4 light wiring
- HELP Fuel Filter Leaking BAD
- wat the heal
- Auto trans not getting into gear after new trans. cooler
- my 12v wont get any fuel pressure need some imput
- lookin for the quick fix
- Transmission Fluid
- nv4500 to nv5600
- sled pulling
- drilled wastegate
- Another Tough to start 12V
- Manual to auto
- lift pumps
- Air Filter question...
- Finished KDP installation - a few observations
- Problem with potentiometer.
- 97 Transmission problem
- South Bend or Valair - Help me decide
- twin turbo, same size
- Clanking noise while shifting into second in my 5spd
- 95 12 Valve Questions??
- Installed new Borgeson box and shaft
- Is there a 2nd Gen Clutch Replacement Tutorial?
- Jerky at low RPM
- Tranny Help! 5 speed NV4500
- Boost question
- Leaking turbo WTF?
- 12v and 6.7
- good tranny shop
- Floatin gears
- AG/industrial block VS truck block
- 97 12v stalling
- 47re question
- injector rebuild in the north east
- Towing with a canopy
- Difficult to drive
- axle swap or just bigger tires?
- 47RH Case Cracked - Seeking Help/Info
- 1/2 way through KDP tab installation... couple of questions
- anybody near scranton pa???
- 12v cummins wont start after kdp fix :/
- Need some help 97 Dually horrible vibration at 70 mph!
- underpowered for dual disk?
- 75W-140 in rear diff
- a/c liquid line NLA
- Torque Converter Help ASAP!!
- 6inch stack...inpute please.
- NV4500 shift tower removal
- '94 won't prime all of the sudden
- Mpg
- single Rear wheel drive to duals
- weird noise help!
- gov spring gone BAD BLEW A HOLE IN MY PUMP
- Rotateing turbo houseing??
- Marine engine??
- help with dana 70 bom
- Dana 70 Problems
- quick question!!! !
- Weak crank when starting
- Can someone tell me what this wire is supposed to be connected to?
- 98 12v performance
- 95 wont turn over, clunks and coolant in oil
- Gauge ?
- 94 240hp ppump
- quick lift pump ?
- Transmission line help putting in temp sensor
- p7100 help!! Guru's help!!
- Tranny Cooler Hose/Barb fitting size
- 1994 12v haveing trouble starting/shutting off
- Someone to set timing, run the valves, in Ky
- NO fuel. Please help!!
- Issue with A/C...system freezing or vacuum issue?
- Injection Pump
- Fuel Plate Advice...Help Me...Post Reply
- Front end rebuild parts list?
| |
|
vBulletin® Copyright ©2000-2013, vBulletin Solutions, Inc.