- pulled the tranny cover cant tell what i am looking at
- Replacing Tranny Gov solenoid
- First 12v what to prepare for
- 3 speed to 4 speed
- Ready for 5 speed swap want some clarity
- Torque Management
- 241 DLD Problems?
- how to find out which trans i have??? 47RH, 47RE, 48RE, or 68RFE
- Installing a fuel pressure gauge
- looking for a good shop in south west North Dakota??/
- Bad injection pump?
- 12v motor questions. From Over the road rig.
- Need help bad tranny
- Engine Break-In
- Overflow tube? Grease leaking onto ground
- Rough idle and dies
- lifting tappets in 12 valve
- My '95 5.9 Cummins won't idle.
- I thought the 12v was an interference design engine???
- Noise under truck when under load
- Cummins rebuild not running right
- ?'s for all you 2.6 guys
- 1/2 tank transfer issues
- front end bearing noise
- NV4500 vent tube
- 96 12v no fuel from #1 dv
- sudden severe oil leak
- wheel bearing going out?
- Nv4500 swap wiring.
- Fast/slow spool
- torque specs!?
- ABS and BRAKE light
- Fuel shut off relay
- fuel coming out of stacks
- v10 47re in 96 12 valve
- truck not shifting from 3rd to 4th right
- NV4500...time for rebuild?
- Multiple 97 12v Questions (Including Cruise Control)
- no powersteering or brakes
- How much HP will this get me.. building trans.
- dash problems causes AC and transmission problems
- pump timing?
- This forum is great.
- Anyone had this problem?
- Bad injector pump symptoms?
- griding noise wile in gear
- Turbo Oil Pipe?
- Still no start...Help!
- No Start - fuel at 3-6 injectors only, help..
- Trans Upgrades for this setup?
- Transfer Case
- 12v towing vs Chevy 350
- new purchase
- Egts
- Sounds like loose change in a dryer coming from tranny.
- He351cw
- Transmission Swap
- Freeze Plug
- AFC Housing wont seal
- TCC problems
- EGT question
- Very hard to start!
- Short gooseneck for spill-port method
- 1995 starter replacement
- WIW, complete Dana 70 with....
- Part number question
- Lost Overdrive
- no power at idle
- Snapped the bolt that goes in the top of the valve cover....help needed
- 2 questions
- I have to cry to someone!!!
- Oil out breather and other issues...
- fuel problems
- Electric Fans
- throttle cable help.
- TV cable adjusted, gas pedal feels hard and seems sluggish
- Truck seems to loose prime when sitting at an angle
- 97 Cummins torque lock up switch problems???
- Rubber in oil plug threads
- tcc lockup problem omg
- Overheating/ Coolant flow issues
- Driveability/Fuel Issue
- Emergency!!!!!
- Vibration what the.....
- P700 help!
- 47RE Help!
- Transmission rebuilder in Indiana?
- 95 dodge a/c issue
- 95 2500 cummins loses overdrive
- Is this bad?
- egt's
- Strength of input shaft
- 24 valve wheels
- 1100-1300 rpm shake
- adjusting timing w/o tools... possible?
- Air in fuel system
- 47RH Transmission rebuild questions
- fried wire
- 95 12V chugging
- should I be worried about blowby here?
- What P Pump Should I Go For?
- 5 speed to auto swap question
- T-case plug size, oil drain plug gaskets question
- Leaking oil out of dipstick on 95 cummins
- Injector Performance Questions
- Tach and fuel gauge not working
- Air Intake Heater Doesnt Shut Down
- Hx35w welded waste gate.
- 47RH problems, any ideas?
- 911 help fast plzzzz
- Size of bolts on shutdown solenoid
- Lift Pump head scratcher
- Injection Pump oil?
- 47re Whining/Grinding
- Stripped bleeder screw
- Weird Idle
- rotary to p-pump
- yes another white smoke question
- 12v/24v compatibility
- Fuel Lines for RCLB
- going to get a source automotive tranny in a few weeks
- harsh garage shifts
- 13" clutch swap from G56 truck
- What injectors do I need
- 95 cummins starting point
- 47re re-builder in Toledo, Ohio?
- 97 12v power loss driving me crazy
- 95 won't idle
- sudden power!?!
- Turbo silencer? Fuel plate?
- 97 p pump project
- Can anyone identify this brand???
- What Gears Should I Be Running
- Th400 in a sled truck ???????
- Delayed 4th and 5th gear
- 97 4x4 12v shifting issue automatic
- pump problems
- lossing coolant
- turbo questions
- help!! throttle stuck wide open after retiming
- 12v clunk on shutdown
- 12 valve vs. CR
- radiato/intercooler----90 degree rotation...ok?
- Turbo locked up and when I drive it, it doesn't blow a lick of smoke
- Major noise coming from front of engine!!!!!
- fuel filter
- 97 Voltage Regulator nightmare.
- Valve body ID
- 5.9 vs 466
- no power steering
- I think its the lift pump this time
- Popping sputtering when cold
- 29s input shaft needed!
- What fuel pressure does a stock lift pump produce?
- 98 3500 Hard to Start
- Pressurizing fuel tank
- fuel filter help
- Vacuum pump reseal, have you done it?
- Avg. labor cost to remove/install injector pump?
- Guys with Aurora 4000.
- Engine fuse
- runaway
- allison 6 speed help in a 96 dodge
- Truck running SUPER cold
- Lower transmission running temp
- Timing with pump pin
- replacing radiator to save trans??
- Pusher Pumps - too much / too little?
- P7100 180hp to 215 swap
- 47re output shaft in a 47rh
- Would like some suggestions.
- FNG to the 12v world
- Just picked up a 97 ext cab 4x4, trans help please
- Engine running hot
- rattle
- engine temp gauge died help!!!
- 47rh issues
- 47re -only goes into reverse -had issues- filled with "wrong" fluid in the past
- Carrier Bearing
- 60 Pin pcm Connecter...
- Twin Turbo Planning
- New to 12v need help with fuel wiring
- Air in system????
- How to get turbo to boost better in bottom end?
- tcc lock-up problem
- turbo question..wastegate arm stuck in horizontal position.is it open or closed
- Shortblock differences
- really need some advice! 1995 governor question
- heading to dyno today
- WTB: #10 plate
- Front axle swap
- Mahle marine piston
- momentary boost problem!!
- Engine serial number location
- Kdp repair kits
- spray outside of bowl
- Tranny Help
- Help FS lever during gov spring
- Repair Manual
- dana 80 spindle thread restoring
- I'm getting terrible fuel milage.
- what to look for and ask
- broke turbo-new wheel and/or shaft?
- Engine Fuse (#9)
- Brake Line
- fue tank not venting & irratic fuel gauge - cause for running bad?
- Synchros again!!!
- fuel problem
- Stock Tach malfunctioning
- pully problems please help
- Bosch H-pump conversion
- Vibration / Tire wear issue
- Egt
- Replacing leaking front crank seal without taking of cover?
- need 12 valve
- more responsive after disconnecting TPS???
- Is fuel transfer pump going bad
- Ratchet shifter/ Converting shift linkage?
- Weird problem... I think
- Need a recommendation of what to buy for the IP gear puller
- PATC, anyone heard of them????
- trouble shooting suvvestions?
- Starter bolts backing out
- Gauge parts help!
- 6.0 PSD Garrett VNT turbo on a 12V
- 2nd gear lockup issue
- fan pulley part
- TC lockup question
- Timing tool
- Delivery valves
- fuel plate problem!
- Need help with wheels !!!!!!!
- Idle to high?
- excessive turbo noise all of a sudden...loss of power...help
- transmission upgrade questions. big name or local shop?
- Fuel Pump vs Lift Pump
- Leakin Oil...FML
- vehicle bucking
- Fuel Solenoid question
- shutter when first put in to gear
- Front axle stub seal replacement
- Dana 80 Drum removal HELP!!!
- just baught a 97...need some help
- looking to buy a 96 12valve and need some help
- Urgent!!!!
- single tire on a dually rear ?
- Need torque specs for injectors.
- Torque converter
- Building trans, need ideas!!!!
- HELPPP! new cummins owner!
|
Pages :
1
2
3
4
5
6
7
8
9
10
11
12
13
[14]
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
| ||
vBulletin® Copyright ©2000-2013, vBulletin Solutions, Inc.