fuel pressure readings with quad adr and cm monitor

**twisted_diesel** · 07-23-2011, 02:59 PM

well i hooked up my quad and was checking out how bad it made the stock LP strugle more than my edge juice did while i wait for my AD 150 to get here but with the quad it says i hve 52psi at idle i know thats inccorect i played with all the FP setting to see if it changed anything and the closest i got was 33psi at idle when i had the edge i had 14psi idle any one else have this problem this is not the pv2 monitor its the older style cm monitor if it matters

**twisted_diesel** · 07-24-2011, 11:41 AM

nobody has this problem

Branden246 · 07-24-2011, 11:52 AM

I had this same problem with mine. It was reading 80-90 psi. I switched to a mechanical gauge and haven't had any problems since. I talked to quad and they said you could send the pulse and adrenaline in and have them updated to read the correct pressure. The mechanical gauge is more accurate and reliable in my opinion.

**twisted_diesel** · 07-24-2011, 02:19 PM

yea i was planning on running an isspro FP guage i was really concerned about FP right now cause i dont have a lift pump on yet im waiting for it to come in but if i have to send it to quad then by the time i gert it back ill have a fp gauge and the AD installed so i guess i have to wait on the AD