Emissions Recall G30 to replace oxygen sensor module and reprogram ECM.
2007-2008 Models (DH/D1) Dodge Ram 2500/3500 Pick Up Truck
NOTE: This recall applies only to the above vehicles equipped with a 6.7L diesel engine ("A" in the 8th VIN position) built throught August 20, 2007 (MDH 082019).
Some of the involved vehicles may be in dealer new vehicle inventory. Dealers should complete this recall service on these vehicles before retail delivery. Dealers should also perform this recall on vehicles in for service. Involved vehicles can be determined by using the VIP inquiry process.
SUBJECT: The On-Board Diagnostic (OBD) system on about 74,000 of the above vehicles may not detect a failed oxygen sensor or illuminate the Malfunction Indicator Light as required. In addition, the OBD system many cause theses trucks to fail an Inspection Maintenance (Readiness) test, and not store mileage as required for certain transmission faults.
REPAIR: The Oxygen Sensor Module must be replaced and the Engine Control Module (ECM) must be reprogrammed (flashed).
NOTE: The new software will also improve vehicle driveabliity and reduce the potential for exhaust soot accumulation in the vehicle's particulate filter.
__________________
Mark's '07.5 Megacab 2500,6.7L,6 Speed Auto/Stick,Buckets w/ full Console,Engine Brake,Stampede Brand Vent Visors,Bugshield,Headlight Eye-Brow Covers,Bedrail and Tailgate Covers w/ Anchors,3rd-Eye Brake Light Cover,Lighted Hitch-Cover,Hi-Beam AND Foglights enabled