Cummins Diesel Forum banner

extrude honing

1K views 4 replies 3 participants last post by  jkidd 
#1 ·
Is Jim Bower still doing nozzle honing? He used to have a webpage called gethoned.com but the page is gone. His number is still good and his voice mail still talks about being a fuel injector specialist but Ive left 2 messages with no response. If hes not doing these anymore who is everyone using to get nozzles extrude honed?
 
#3 ·
What size are you looking for? Are you looking for the better honing on the AFM machine that keeps k-factor of the nozzle or standard honing?
 
#5 ·
Will send you a PM
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top